Model #4360-47 Foote\dana transaxle/transmission, tractor

  • Transaxle
    3 Results

Question and Answers

Q:

INTERNATIONAL HARVESTER MODEL 47

A:

Thank you for your question on the timing of the older model 47 IH square hay baler.

I am sorry but I do not remember the full process for timing the baler. It sounds like you may have sheared a shear pin or the timing for the twine ties are not in time with the plunger. What I do remember that if you sharpen the knives and move the plunger of until you get a clearance between the plunger and the knives of about 5/32 of an inch it should tie the knot better.

I will give you a link for acquiring the service manual for this baler below.

IH model square baler manual .

Yesterdays tractor has the service manual for this baler . You can also call them @ 1-800-583-2651.

Thank you.

Sam A.

Read More
Sam A -
Sears Technician
May 25, 2012
Q:

417.44152400 Error Code 47

A:

That E47 code normally indicates that you have a bad door lock assembly. In rare situations, a wiring problem or a bad control board could cause that code. If you want to fix this problem yourself, then replacing that door lock assembly (part 131763202) should fix your problem. You can order that part from this page: Door Lock and Switch Assembly for Kenmore Washer Model 417.44152400 . Be sure that you unplug the washer before accessing internal components. That link for a previous answer that Marc posted in the above response shows how to replace that component.

If you suspect that you have a wiring problem or a control board failure, reply with additional details and we will assist you further.

If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
August 30, 2012
Q:

Why is my Kenmore washer model 417.44052400 getting the error code 47?

A:

You may want to check the wire harness connections on the control board before replacing any components. Unplug the washer before accessing internal components. I provided a portion of the wiring diagram that covers the door lock circuit in the first image below. The second image shows access information for the control board. Although your resistance check was okay on the door lock assembly, this is usual component that will cause the E47 error code. Since the washer will spin in the diagnostic test mode, this normally indicates that the control board is okay. If you replace the control board and still have the same problem, you may need to replace the door latch assembly as well. (NOTE: Make sure that you counted the blinking lights to determine the error code properly.)

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
March 26, 2010