Model #4360-113 Footedana transaxle/transmission, tractor

  • Dana Transaxle 4360-113
    3 Results

Question and Answers

Q:

tablesaw mod # 113 . 226640 out of square 113 . 226640

A:

Thank you for your question on the table miter slot not square with the saw blade.

If you have used a sliding miter square in the groove of the miter slot and slide the square up against the blade on a tooth that is pointing to the left at the back of the blade slot. Then move the same tooth forward and slide the square forward and if it is off the 64th as you mentioned you may be able to get it to true up by loosening the trunnion motor mounting screws and see if you can move which ever end is off and re-tighten the screws.

There is not much of a adjustment for this problem, so make sure you blade is true and the motor are is not bent.

Please let me know if you could get enough movement to true the blade to the miter slot.

Sam A.

Read More
Sam A -
Sears Technician
October 01, 2012
Q:

113 177490 wet vacuum

A:

Thank you for your question.

I can understand your question as to whether to remove the filter or not when vacuuming water.

  • To be on the safe side I would remove the filter, so you eliminate the possibility of damaging the filter.

I have giving you the recommendations from the page in the owners manual that you can use to make your decision as to taking the filter or leaving it in.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
November 06, 2010
Q:

How do I put a tabletop on a radial arm saw?

A:

The tables are held to the base of the saw with bolts and nuts. If you go to [www.searspartsdirect.com], you can see a parts diagram and list for the saw. At [www.managemylife.com], you can download or print an owners manual for the saw. The owners manual gives you the instructions for installing the front and rear tables on the saw.

Read More
Jimmy K -
Sears Technician
July 13, 2009