Model #43358-OB Frigidaire upright freezer

  • Doors
    3 Results
  • Doors Page 2
    3 Results
  • Cabinet
    3 Results
  • Cabinet Page 2
    3 Results
  • Electrical Systems
    3 Results
  • Electrical Systems Page 2
    3 Results

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

calypso washing machine went into OB mode a will not reset

A:

To reset the control after experiencing this code, you must lift the lid. The control will see that the lid was opened and the washer should resume normal operation. If this does not work, I recommend that you try unplugging the washer for 3 minutes. Plug the washer back in and this should reboot the control board. See if the washer resumes normal operation. If the washer still will not function properly, it will likely need service by a technician. Here is a link for the Sears Service website: Sears Home Services .

NOTE: Due to the likely age of this washer and the cost of parts that may be needed to repair this failure, you may need to consider replacing the washer instead of repairing it.

Read More
Lyle W -
Sears Technician
May 17, 2010
Q:

ld and ob error 11022064102 Kenmore Elite Washer

A:

You should not have to reset or program the control board after replacing that drain pump. The Ld code may be appearing because you have a stuck water level pressure switch. The ob code will appear when the motor detects an out-of-balance load or a problem with the drive system. You could have a problem with the universal joint in the drive system.  I recommend that you have a service technician examine the washer and repair these problems. 

 

If you need more help, let us know. 

Read More
Lyle W -
Sears Technician
November 26, 2013
Q:

how to change the primer bulb ob craftman chainsaw model number 358 350080

A:

The replacement primer bulb for the engine (part 530071835) is shown in the image below. I did not find a service manual available for this chainsaw. The video that Jacqueline S provided in the previous response should help you replace the primer bulb on this chainsaw. According to the parts diagram (available in your owner's manual), you will need to remove the cylinder head and then you should be able to remove and replace the primer bulb.

If you do not feel confident repairing this problem yourself, then you can have it repaired by a Sears technician. Here is a link that will provide the nearest drop-off locations: Sears Home Services .

Read More
Lyle W -
Sears Technician
June 22, 2010