Model #43-355 DELTA router accessory

  • Table And Stand
    3 Results
  • Handwheel And Motor
    3 Results

Question and Answers

Q:

Which orifice is the LP orifice, #43 or #55?

A:

The #43 orifice is the Natural gas orifice. I added the instructions below on how to convert to LP so you will need to reverse the procedure to convert it back to Natural gas. The #55 is the LP orifice.

Read More
Joey S -
Sears Technician
March 09, 2010
Q:

Washer wont stop filling, The hose is 43" from the floor!

A:

You did not clarify if water is siphoning out the drain hose while it's filling or if the water is overfilling the tub. Since you indicated the hose is 43 inches above the floor I must assume water is siphoning out while filling causing the tub to never reach the proper water level and begin agitating.

You may have the end of the drain hose stuff to far down into the stand pipe or there is no air gap between the pipe opening and the drain hose. If water is siphoning while filling slowly begin to pull the drain hose up until it quits siphoning. There is also a siphon break available too. You can purchase a siphon break at Sears Parts Direct .

Read More
Joey S -
Sears Technician
August 05, 2010
Q:

kenmore model 417 48102701 error code 43

A:

Hi Austin,

Thank you for submitting a question to Manage My Life.

I am including the tech sheet for this model in the images below. According to the tech sheet for this model, the E43 error indicates a control board problem. The older models have an E43 that points towards a door lock issue. In the checks column it states replace the control board.

You most likely need to replace the control board.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website; Sears Home Services .

Here is a link that you may use to purchase the control board for your Kenmore model number 417.48102701 washer .

I hope this is helpful, and if I may be of further assistance please include more details in a reply to this post.

Landell

Read More
Landell -
Sears Technician
April 09, 2012