Model #41799970110 KENMORE Laundry Centers/Combos

  • Cabinet Parts & Heater
    3 Results
  • Console Controls, Drum
    3 Results
  • Dryer Motor, Blower, Belt
    3 Results
  • Tubs, Water, Valve, Lid Switch
    3 Results
  • Washer Drive System, Pump
    3 Results
  • Transmission, Water Seal, Lower Bearing Assy
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

washer belt replacement for kenmore all in one washer dryer

A:

Thank you for your question.

  • To remove and replace the belt on this washer you will need to gain access by removing the front panel on the washer.
  • There will be two screws in the front at the bottom of the panel and then slide the panel down and towards you to unhook the front panel from the side panels of the washer.

  • Once removed you should be able to see the belt and remove off the pulleys as shown in the picture below.

The part number for the belt is: 5303280326 and you can order this from Sears Parts Direct .

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
September 23, 2010
Q:

wiring diagram

A:

Thank you for your question and I understand your concern.

I was not able to locate the exact wiring diagram for your specific model. If the temp switch has two orange wires, these two would close for high heat.

If you do not have two orange wires connected to the temp switch, reply with colors of the wires connected to the temp switch for further assistance. 

Read More
Joey S -
Sears Technician
August 16, 2013

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show