Model #390 Brother fax machines

  • 1. Recording Mechanism
    3 Results
  • 2. Frame Attachments
    3 Results
  • 3. Auto Document Feeder
    3 Results
  • 4. Auto Cutter
    3 Results
  • 5. Cover
    3 Results
  • 6.5 Control Panel
    3 Results
  • 10. Handset
    3 Results

Question and Answers

Q:

Pro-Form 390 E resistance sporadic

A:

I don't have technical information available for that elliptical exerciser. Your symptoms point to a problem with the control console since the resistance motor will increase the resistance momentarily according to your details. Replacing the console (part 285788) may fix your problem. You can order that part from this page: ProForm 390E Model 831.239430 Console.

Read More
Lyle W -
Sears Technician
February 14, 2013
Q:

bearing for flywheel on a pro-form 390 e elliptical

A:

Thank you for your question.

I have looked up the model number you have submitted. The flywheel should have two bearings that are the same. The part number for the bearing is 172638 and can be ordered from our parts website: Sears Parts Direct . I am sorry for the misprint in the parts list.

Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
November 16, 2011
Q:

No Resistance on my Pro Form 390 E, though console seems to be working fine

A:

Thank you for your question.  I am sorry you are having a problem with the elliptical. If the unit was working fine before the batteries went dead and you connected the transformer, the problem is either in the console or the motor. The easiest way to determine the problem is to check the voltage at the motor. The question you were on has the voltage checks. If you do have the correct voltage at the motor, I recommend replacing the motor. If you do not have the correct voltage, check the voltage on the same wires at the console. If you do not have the correct voltage there, the console is defective. To access the motor you need to loosen the side covers. To do that, refer to the image below. Just click on the image to enlarge it. First remove the rear cover (key number 59) and the top shield cover (key number 37). The rear cover should pry off and the top shield slides up. Once removed take out the screws in each side of the side covers. After they are removed, you should be able to spread the covers apart far enough to access the motor. Once you have access to the motor make the voltage checks. After the failed part is found, you can order the part from the following link. Pro Form 390 part  I hope this is helpful. Please let me know if you need further assistance.  Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
March 07, 2013