Model #37-2227-00-02 TAPPAN Ranges, Electric

  • Cover
    3 Results
  • Body Parts
    3 Results
  • Backguard
    3 Results
  • Door Parts
    3 Results
  • Cooktop, Broiler And Backguard
    3 Results
Find part by diagram >

Question and Answers

Q:

I am getting a F7 02 code on my kenmore electric range model # 790.4661. I have read many of the questions and answers but still need help.

A:

I understand your concern and since you have already replaced the Oven Control/Clock Timer and it' still displaying the fault codes we can assume the failure is likely the touch panel.

The "F701" fault code is likely caused by a loss of a keyboard tail connection.

The "F702" fault code is likely caused by a shorted keypad.

Since the Electronic Oven Control (EOC) has been replaced, the failure is likely the Glass Touch Panel providing you do not have a loose keyboard tail connection.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services

Read More
Joey S -
Sears Technician
November 18, 2010
Q:

what is error code F 02 mean

A:

Thank you for your question and I understand your concern.

The "F02" fault code displays when the drain time exceeds 8 minutes. This can happen if the drain pump filter is restricted or if there is too many suds due to the wrong type of detergent being uses or too much detergent being used.

I added an image below showing how to access the drain pump filter. NOTE: Be sure to have all the water removed from the tub before removing the drain pump filter. You will also need to disconnect the power cord from the power source before removing the front lower access panel.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
July 05, 2011
Q:

Sears random orbital sander 172.25927. The outer hook and loop pad for this sander ripped. Need the part # for it so I can order. Thanks

A:

Thank you for your question on the random orbit sander hook loop pad.

I have updated the information in this thread and sent it to your e-mail. This should resolve your issue with the sander.

Sam A.

Read More
Sam A -
Sears Technician
October 03, 2012
A:

Update on the sander hook loop pads. If you have had a problem with getting the correct sanding paper it may be the cause of your problems with the hook loop. I will e-mail you some manufacturer contact information that will help you resolve this issue. Sam A.

Read More
Sam A -
Sears Technician
October 03, 2012
See more answers