Model #37-1042-23-04 TAPPAN Free Standing, Electric

  • Front Cover
    3 Results
  • Body
    3 Results
  • Control Panel
    3 Results
  • Door
    3 Results
  • Top
    3 Results
  • Burners, Drip Pans, Elements
    3 Results
  • Backguard
    3 Results
Find part by diagram >

Question and Answers

Q:

GE profile top freezer too warm

A:

We can likely provide some technical tips that may help you resolve this problem but we will need to have the model number of your GE Profile refrigerator.

Here are some general tips that may help:

  • Check the back wall of the freezer for excessive ice or frost when the cooling deteriorates. A problem with the automatic defrost system could be causing the temperature fluctuations.

  • Monitor the compressor motor when the freezer is too warm. If the compressor is not running, you could have a problem with the control, the compressor or the wiring.

An intermittent problem can be difficult to diagnose. As noted above, reply with the model number and we will try to provide some detailed troubleshooting tips.

Read More
Lyle W -
Sears Technician
January 01, 2011
Q:

Any one with the same problem with samsung washing machine WF448AAP/XAA 04

A:

I researched that part. The bottom portion of that dispenser housing is only available as a complete dispenser housing assembly (part DC97-14522A). Here is a direct link for that part: Dispenser Housing for Samsung Washer WF448AAP/XAA 04 .

Read More
Lyle W -
Sears Technician
March 24, 2012
A:

Let us know if that part fits properly if you get the chance. Let us know if you need more help.

Read More
Lyle W -
Sears Technician
March 26, 2012
See more answers
Q:

What would cause my dryer to take 2-3 cycles to dry?

A:

First, if your dryer is an electric dryer and not gas remove the vent hose from the rear of the dryer and dry a load. If it dries the clothes in one cycle normally that would indicate a venting issue. Open the door and remove the lint filter and check for a blockage down in the lint filer housing. Inspect the lint filter, take the filter and run water over it to see it the water will pass freely through it. If you use fabric softener it will leave a clear layer over the little holes and restrict the airflow. Take the lint filter and wash it off with water and a brush. Use a vacuum to clean the lint out. Any airflow problem will cause the dryer to take longer to dry. If it's a gas dryer it could have weak gas solenoid coils and it's not always opening the gas valve.

If you’re confident that there are no air flow restrictions I recommend calling a service technician to diagnose and repair your dryer.

Read More
Joey S -
Sears Technician
July 16, 2008