Model #37-0007-00-05 TAPPAN free standing, electric

  • Front Cover
    3 Results
  • Cooktop Parts
    3 Results
  • Door Parts
    3 Results
  • Backguard
    3 Results
  • Drawer Parts
    3 Results
  • Body Parts
    3 Results

Question and Answers

Q:

what does code f 05 mean

A:

The "F05" fault code indicates a Water Temperature Sensor Error. If during the water heating step in the wash cycle, the water temperature sensor (NTC) value is out of range, the "F05" error code will be displayed. See image below for further instructions.

Potential Causes:

  1. Check the Water Temperature Sensor resistance. It should measure 9.7K ohms at 86 degrees.
  2. Check connections to the Water Temperature Sensor
You will likely find the wire connection had come loose from the temperature sensor. Without having the model number of your HE3t washer I will not be able to confirm if the heater and sensor is located at the lower backside of the tub or at the front lower section of the tub. Disconnect the power cord from the power source before removing the front lower access panel and checking for loose connections on the temperature sensor.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
August 04, 2010
Q:

lidlock is on, off, blinks, basket not spin, not agitate. WTW4950XW0 Whirlpool Automatic washer

A:

Make sure that the pulleys are tight. Tighten any loose pulleys and use some thread locking adhesive to prevent them from getting loose. 

Unplug the washer before accessing internal components.

If the pulleys are okay, then you could have a problem with the shifter assembly or other drive components.

When the lid lock blinks, the washer usually records an error code. I emailed a document to you that show how to enter the diagnostic test mode and read the error codes. The blinking lid lock light does not necessarily indicate that the lid lock mechanism is defective. I recommend that you use the diagnostic test mode to determine the likely cause of your failure.

If you need more help, let us know.

Thanks for choosing Sears PartsDirect.

Read More
Lyle W -
Sears Technician
March 31, 2014
Q:

Craftsman lawn tractor -- engine seized

A:

Thank you for your question and I understand your concern.

Remove the spark plug and then see if the engine will spin over. If it battery and starter is okay and the engine will not spin over, then the engine very well could have seized up due to the lack of oil circulation when it was on the severe sideway incline.

It would likely cost less to replace the engine rather than having it rebuilt. I was not able to price the replacement engine. The parts list shows the replacement engine is part #311707-0028-E1.  I strongly suggest taking the mower in for an estimate of repair. It may cost less to have the engine replaced but I can't be certain. 

 If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link:Sears Home Services.

Read More
Joey S -
Sears Technician
April 18, 2013