Model #36-560 Delta saw table

  • Table/fence/base
    3 Results
  • Guard/armature/blade
    3 Results
  • Leg And Stand Assembly
    3 Results
  • Wiring Diagram
    3 Results

Question and Answers

Q:

Kenmore Mod 110.27062600 ser CT0670781 Type 560 Controller is messed up. Flashes random times on timer display, Did reset after being unplugged for some

A:

Your details indicate that the control reset and stopped flashing random numbers after you unplugged it for some time. The details seem to be cut off. If unplugging the washer completely reset the control then it should be okay. Power surges or glitches through the electrical lines can scramble or damage the electronic control board or user interface control board in this washer. If the boards reset and continue to work properly then you should not need to replace either of them at this time. If the condition returns, then you may need to replace one or both of the control boards. If you are getting frequent, random changes in the user interface display, then the user interface control board may need to be replaced. The part number for the user interface control board is 8564393. You can order this part from the Sears PartsDirect website. Here is a link for a previous answer that provides more advanced troubleshooting and access information for this type of problem: Why won't my Kenmore Elite washer model 110.27082601 work?

If you are certain that the user interface control board is bad, you can use the information in the above link to replace that component. Be sure that you unplug the washer before accessing internal components.

The part number for the machine control board is W10189966. There are instances where this control board will need to be replaced along with the user interface control board to correct the type of problem that you are describing. The above link also shows how to replace this control board.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
June 08, 2010
Q:

microwave 36" above floor...Why?

A:

If you are referring to installation guide or owner's manual specifications for a counter top or built-in microwave, it is likely for safety. Bending down below 36" to remove hot food from a microwave is normally considered unsafe. If you need more help or information, resubmit your question with additional details and the model number of the microwave that you are inquiring about.

Read More
Lyle W -
Sears Technician
May 07, 2010
Q:

kenmore pro 36

A:

The breaker size, copper wire size and KW rating for this range is shown in the image below. That is essential information that an electrician normally needs to install this range. Here is a direct link for the full installation guide for this range: Installation Instructions . It may take a minute or so for that link to download and open up.

Here is another link for the same manual that may be easier to navigate: Installation Instructions

If you need more help, let us know.

Read More
Lyle W -
Sears Technician
March 18, 2011