Model #36-540 Delta table saw

  • Unit Parts
    3 Results
  • Guard Assembly
    3 Results
  • Motor Assembly
    3 Results
  • Outfeed Roller Support Assembly
    3 Results

Question and Answers

Q:

My Proform 540 s is inclined fully and will not go down The motor keeps running. What should I do?

A:

Several things could cause the incline motor to keep running in the up position. The console or the motor controller might have failed. Some wires might be shorted in the wire harness between the console and the controller. The photo switch and optic disc on the incline motor might be bad or out of position. These items will require diagnosis with a volt/ohm meter.

If the motor tries to run when it is stalled, it will damage the windings and the incline motor will have to be replaced. Don't let the motor try to run too long.

I recommend you schedule service and let a technician diagnose and repair the problem.

Read More
Jimmy K -
Sears Technician
January 25, 2010
Q:

Can you tell me in what year this unit was manufactured

A:

Thank you for your question.

I have checked the model number you have submitted. This edger is a 1994 model.

Please reply below if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
October 26, 2010
Q:

microwave 36" above floor...Why?

A:

If you are referring to installation guide or owner's manual specifications for a counter top or built-in microwave, it is likely for safety. Bending down below 36" to remove hot food from a microwave is normally considered unsafe. If you need more help or information, resubmit your question with additional details and the model number of the microwave that you are inquiring about.

Read More
Lyle W -
Sears Technician
May 07, 2010