Model #36-3272-00-10 Tappan range (gas)

  • Cover Page
    3 Results
  • Backguard
    3 Results
  • Control Panel
    3 Results
  • Cooktop Parts
    3 Results
  • Door Parts
    3 Results
  • Panel Compartment
    3 Results
  • Broiler Drawer Parts
    3 Results
  • Burner, Manifold And Gas Control
    3 Results
  • Body Parts
    3 Results

Question and Answers

Q:

I started my GE self clean oven at 10:00 and electric went off for just a second and came back on and it ran for 10 hrs and won't go off. GE oven

A:

Thank you for your question and I understand your concern.

The electronic oven control will display "F3" fault code when the oven temperature over heats or if the oven temperature sensor Ohm resistance exceeds 2900 Ohms. If leave the power supply off to the range and then re-connect the power and the oven begins to heat, the electronic oven control was likely damaged due to the electrical storm. Since I do not have model number I will not be able identify what type of door locking mechanism it may have or how you would access it. If you have the Owner's manual of the range, it should have one or more model numbers listed on it that would be helpful.

The range/oven will most likely need a new electronic oven control/clock assembly.

 I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post along with the model number on the cover page of the Owner's manual.

 If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services.


Read More
Joey S -
Sears Technician
April 12, 2013
Q:

My Craftsman 36 inch model 247889360 runs for 10 min then cuts off and will not restart. Why?

A:

If the mower runs for close to the same amount of time each time you use it and shuts down, then won't restart for 15-20 minutes, it probably has a bad fuel cap.

The fuel cap has a breather built into it that lets air into the tank to fill the space that is created when the fuel is burned. If the air doesn't fill the tank, the tank will vapor lock and fuel stops flowing to the engine.

Try removing and reinstalling the fuel cap every 5 minutes. If this stops the problem, replace the fuel cap.

Read More
Jimmy K -
Sears Technician
March 23, 2009
Q:

Can you send me the deck belt routing for my Sears LT 10/36 model 917.255271?

A:

We don't have a true deck belt routing diagram for your mower. I am sending you an image that shows some information for routing the belt.

When you move the deck engagement lever forward the linkage should move the idler pulley against the belt to tighten it and cause it to drive the pulleys.

I hope this helps some.

Read More
Jimmy K -
Sears Technician
May 29, 2009