Model #36-3052-66-08 Tappan range (gas)

  • Cover Page
    3 Results
  • Backguard
    3 Results
  • Control Panel
    3 Results
  • Cooktop Parts
    3 Results
  • Door Parts
    3 Results
  • Panel Compartment
    3 Results
  • Broiler Drawer Parts
    3 Results
  • Burner, Manifold And Gas Control
    3 Results
  • Body Parts
    3 Results

Question and Answers

Q:

remington22lr model 66

A:

I see that Marc posted a link in the above response for the page on the Remington website that has the Owner's Manual links. That should help you find the manual for the Remington Model 66 rifle.

Read More
Lyle W -
Sears Technician
December 26, 2012
Q:

my ignitor has 66 omhs instead of 40 omhs is this a problem

A:

Thank you for your question.

I can understand wanting the information on the igniter.

Yes, I would change the igniter if the ohms are that far off. It needs to be real close to 40 ohms or it will not get hot enough satisfy the sensor and open the gas valves.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
December 10, 2010
Q:

Vacuum problem. Bought 02/06/08

A:

Thank you for your question.

I can sure understand your concern as to why you need to hold the hose and handle together to get the Power Mate to work.

• The problem you are having if I understand your description correctly is that the wire connection where the hose meets the handle is not making a good connection all the time.

• There are two other connections that are possible depending on where you are putting the pressure.

• If you are just pushing down on the handle the plug in connections where the lower wand plugs into the Power Mate is one possibility. The other location is where the upper wand plugs into the hose handle assembly.

• If you are pushing on where the hose goes into the handle then it is probably is a broken wire in the hose.

• The wire coils on the hose is what carries the electricity from the vacuum canister to the handle switch and then down the wands to the Power Mate.

• If you can isolate the bad connection to be sure that you are going to be replacing the correct part.

• If it is the hose wires I will give you some pictorial instructions as to how to replace the hose assembly below.

• If it is in the handle harness plug you will need to take the handle apart and replace the handle harness.

• The handle has recessed screws that hold the handle together and one hidden screw at the back of the hand hole to hold the switch cover on.

• The wand wire harness can only be changed with a replacement lower wand.

• If the bad connection is in the Power Mate connection plug you will need to disassemble the Power Mate to replace that harness.

If you have Isolated the problem area please use the link to get more detailed instructions on how to repair.

I hope this will help with your vacuum cleaner.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
November 05, 2010