Model #36275210102 KENMORE Free Standing, Gas

  • Gas & Burner Parts
    3 Results
  • Control Panel & Cooktop
    3 Results
  • Body Parts
    3 Results
  • Door & Drawer Parts
    3 Results
Find part by diagram >

Question and Answers


Oven won't heat up 36275210102 Kenmore Gas range


Hello glad to help.  Thank You for choosing Sears
I am sorry and do understand your frustration when working on the Kenmore Gas Range.

Glad to help out.   Im  looking at your model number 362.75210102.
Glad to help out.  First thing to check on the range is the ignitors.   Just because they light up doesn't mean they are good.   Please turn the bake on and see if lights up quickly and see if it is a glow of bright red or orange.  IF red then it is great if an orange then you need to replace the ignitors.   Next check the broil and see if that is igniting faster.   You have the same ignitors so you will be able to exchange them to check if one is good or bad.  
Providing then that you see the ignitor is good.   Maybe just needs cleaning.   If not the ignitor then you most likely need a new  bake tube.   I  have the link on the bottom for both.
 How to check an ignitor and how to clean a bake ignitor:

How to check if ignitor is good:

1.  Lower the door all the way down.   May have to remove the hinges so be careful.  The ignitor will be on the back bottom side of the oven.  Usually a cylindar/oblong piece and has a metal covering.  2 wires on the back side with ceramic wire nuts.

2.   Turn the gas on and wait for the ignitor to start glowing.  If it takes more than 2 minutes to do then needs to be replaced.

3.  If it is coming on then look and see if it is a dull orange/reddish flame.  The probablility is that  there is no longer enough current flowing through.  Then ignitor needs to be replaced.

Instructions on cleaning ignitor:

1.  Please remove the racks from inside the oven.  

2.  Locate the ignitor on the back bottom side.

3.  Unscrew the screws that holds the ignitor to the oven and pull out the wire clip.  The ignitor is fully disengaged and now can be removed from inside the oven.

4.  Soak the ignitor in a plastic container filled with solvent.  Soak it for around 20 minutes.

5.  Take out the ignitor from the solvent and try to dry with a paper towel carefully.

6.  Spray your ignitor with a can of compressed air so it will remove any left over particles.  Then just reinstall the ignitor by the way that you removed it.
Turns out too in that if you order the burner bake tube it comes with a new ignitor.

 If you have further questions please let me know.
Thanks for choosing Sears

Read More
Larry L -
Sears Technician
September 16, 2013

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show