Model #3627271190 Kenmore free standing, gas

  • Burner Section
    3 Results
  • Main Top Section
    3 Results
  • Cabinet
    3 Results
  • Door
    3 Results

Question and Answers

Q:

Oven overheats after changing from LP gas to natural gas

A:

Thank you for your question and I understand your concern.

I added an image below of the instructions for converting it to LP gas. Reverse the procedure to convert the range/oven to Natural gas.

You may need to turn the oven burner spud clockwise to reduce the size of the oven flame.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
January 07, 2013
A:

George: Converting the range from LP to Natural gas should not have any effect on the operating temperatures if it working properly in the past. Based on your symptom it sounds like you will need to replace the oven thermostat. The oven thermostat is part #WB20K5 at the cost of approximately $155.39. At that price you may want to consider replacing the range.

Read More
Joey S -
Sears Technician
January 05, 2013
See more answers
Q:

oven will not come on

A:

Check to see if the ignitor on that oven burner is glowing when the oven is set in the bake mode. If not, then you will probably need to replace that oven thermostat on the console or the ignitor. If you have a volt/ohm meter, you can unplug the range and check the continuity through that ignitor. If the ignitor is okay, you will need to replace that thermostat. If the ignitor is glowing, then all of the other components are apparently okay and you will probably need to replace that ignitor to fix this oven failure. The theory of operation for that ignition system on your oven is shown in the image below. Even though the ignitor is glowing, it is probably not heating to a point where it is allowing enough current through the circuit to the safety gas valve. That is why the ignitor will normally be replaced when it is glowing but the burner will not light.

You can order parts from the Sears PartsDirect website.

Be sure that you unplug the range before replacing internal components.

If you need more help, reply with additional details.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
November 15, 2011