Model #360VS (TYPE 5, 6, 7) Porter Cable sander

  • Belt Sander
    3 Results

Question and Answers

Q:

Toaster shade keeps resetting to 5 after I move it to 7. How do I get it to stay at 7?

A:

It sounds like you have a problem with the control on the toaster. I don't have access to the owner's manual for that toaster. If you have checked the owner's manual and the toaster is not operating properly, I recommend that you return it to the store for an exchange since it is brand new. That type of toaster normally has a 2 year manufacturer warranty.

If you need more help, let us know.

Read More
Lyle W -
Sears Technician
June 27, 2011
Q:

Why haven't I rec'd answers from 6 and 7 days ago when should have been within 2 days as indicated.

A:

Without a model number, I can't tell you what F-2 means on your range. If you want a specific answer send another email and include the model number of the range.

On most Kenmore ranges F2 means the electronic oven sensor has failed. F2 can also be caused by a defective control board.

I apologize for the delay in answering your question. We got behind during the holiday season because of vacations and we are trying to catch up. We will have things caught up in another 7-10 days and get back on schedule.

Read More
Jimmy K -
Sears Technician
Q:

How to install the Kenmore Downdraft Blower 59940

A:

The reference information on page 5 of the manual indicates that the blower will still move 80% of the rated air capacity when using 200 equivalent feet of 7" duct work. This is just a statement for illustration purposes.

The actual venting requirements recommend that you limit the duct work to less than or equal to 40 equivalent feet of 6" duct work.

Using 6" duct work is normal. Just minimize the length of the duct work as much as possible.

I hope that this explanation answers your question. If you need more help, reply with additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
November 23, 2010
A:

The manual lists "equivalent" length for the elbows and other fittings. A 6" round elbow has an "equivalent" length of 8 feet. This should be the length that is added to the duct work calculation when you use that type of fitting. The total "equivalent" length of the duct work should normally not be more than 40 feet for the vent to work properly. If you extend the venting past that equivalent length, you will experience diminished air flow below the rated capacity. Keep in mind the reference point that 200 equivalent feet of 7" round duct work will still allow the system to operate at 80% of the rated capacity. Although it is not recommended, extending the venting past the 40 feet of equivalent duct work will still allow the blower to work reasonably well. Also keep this in mind: extending the duct work past the 40 equivalent feet could affect your warranty coverage if the blower experiences problems or is not moving the expected amount of air. I hope that this additional information helps. If you must extend the duct work past the recommended amount, you should be okay even though there are some slight risks.

Read More
Lyle W -
Sears Technician
November 24, 2010
A:

You can use the flex tubing and it should not leak if it is installed and sealed properly. I don't recommend it but it is possible to use it. I recommend that you use the components shown on page 5 of the manual. The note at the bottom of page 6 states that the equivalent feet of the wall or roof cap is taken into account and should not be counted with the 40 equivalent feet of duct. I hope that this additional information helps. If you need more assistance, let me know.

Read More
Lyle W -
Sears Technician
December 06, 2010
See more answers