Model #358797170 Craftsman blower, gas

  • Housing/handle/fuel Tank
    3 Results
  • Cylinder/crankshaft/crankcase
    3 Results
  • Bag And Tube Assembly
    3 Results

Question and Answers

Q:

358797170 how do get knolling off?

A:

Thank you for your question.

I am sorry you are having a problem with the blower. I have not heard of the term knolling. If you could please reply below with more details, I will be happy to assist you with the repair.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
April 14, 2012
Q:

Basic carburetor needle settings 358797170

A:

Thank you for your question.

 

If the mixture screws on the blower are adjustable, the initial setting for the mixture screws is 1 1/4 turns out. This setting should get the blower to run. Once it is started, run the blower at full speed and turn the high screw out until it runs rough. Then turn the screw in and count the turns until it runs rough. Then set the screw in the center of the two points. Now do the same with the low speed when the blower is idling.

 

If you can not get the carburetor adjusted correctly, there might a plugged passage or a failed gasket in the carburetor.

 

If you need further assistance, please reply below.

 

Thank you for using Manage my life.

 

Mark T

Read More
Mark T -
Sears Technician
November 12, 2013
Q:

I need to replace the gas lines and filter in my blower model 358797170. Can you send me the routing for the fuel lines?

A:

You have one large fuel line and one smaller. This eliminates some chance for error. If you have 2 small fuel lines to the carburetor connect them and start the engine. Reversing the fuel lines will not prevent the engine from starting. If you have them connected backwards, the engine will start and die. Reverse them and you will be correct.

The routing of the fuel lines vary from model to model. Keep in mind that the primer bulb circulates fuel from the tank, through the carburetor, and back into the fuel tank. One line goes from the fuel tank to the carburetor. One line goes from the fuel tank to the primer bulb, from the primer bulb to the carburetor, and back to the fuel tank.

Read More
Jimmy K -
Sears Technician
September 11, 2009

Recommended maintenance parts & accessories

Show 3 more
No more item to show