Model #358360130 CRAFTSMAN chainsaw, gas

  • Housing/handle/chain/bar
    3 Results
  • Cylinder/shield/carburetor
    3 Results

Question and Answers


how to put fuel line in tank on chainsaw md 358360130


Thank you for your question.

I am sorry you are having a problem with the chainsaw. We do not have any written instructions for replacing the fuel line on chainsaws but I will try to help you. First, remove the air filter cover and the air filter. Then draw a diagram of how the fuel line is routed. I have also provided you with an image below showing the fuel line circuit. Then remove the all of the old fuel lines from the saw. When you are ready to reinstall the line cut one end so that it is tapered about an inch up. This will give you something to stick into the hole of the tank. Once in the hole reach into the tank with long forceps and grab the line and pull it through. Once you have it pulled in cut the pointed end off and install the filter. The line should be long enough so the fuel filter is on the bottom of the fuel tank. Then do the same for the return line. The only difference is the return line only has to be sticking in the tank about a half an inch.

I have found a few videos that I think might help you. Please click here to watch the first video . Then click here to watch the second video.

If you need further assistance, please feel free to reply below with more details.

If you do not feel confident repairing this problem yourself, then you can have it repaired by a Sears technician. Here is a link that will provide the nearest drop-off locations: Sears Home Services .

Here is a link to order any parts you need. Sears Parts Direct .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
October 30, 2011

I have a Craftsman chainsaw model 358360130. I am running the gas line into the tank. I need a short cut. The nipple is too far in the tank.


You might need some longer needle nose to reach the fuel line and pull it into the tank. You need to get enough fuel line into the tank, then bend a hook in a piece of clean wire and hook the fuel line. Pull the end of the fuel line out of the tank and connect it to the fuel pick up filter. Drop the fuel pick up into the fuel tank.

The return line only sticks into the tank 1 inch or so.

Read More
Jimmy K -
Sears Technician
October 26, 2009

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show