Model #358360121 Craftsman chainsaw, gas

  • Chasssis/housing/handle/bar/chain
    3 Results
  • Cylinder-shield/cylinder
    3 Results

Question and Answers

Q:

chain saw 358360121 need schematics. leaking oil everywhere, could it be the large tube or an o-ring? leaks oil even when not in use

A:

Thank you for your question.

I can understand not wanting the oil mess around the chainsaw.

In some cases after using the saw if you will release the oil filler cap it will depressurize the oil chamber and this will help with the leakage.

If your case however it sounds like the oil supply pipe coming from the oil tank going to the oil pump is leaking.

  • You will need to remove the bar and chain assembly.

  • Then you will need to remove the clutch off the crankshaft. You will see an arrow on the clutch center pointing in the direction of removal. You can take a large flat blade screwdriver and palace it on the wing of the center hub by the arrow and give it a quick tap with a hammer in the off direction.

  • The clutch should then spin off the crankshaft and then remove the large washer and the clutch drum. This will expose the oil pump that is held in place with two screws.

  • Check the seal where the rubber elbow comes out of the tank and attaches to the oil pump. This is the usual place that it can leak from. It may not be seated correctly.

I have given a parts breakdown picture below and I am referring you for the area in the box which is the related oil pump and supply tube parts.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
January 22, 2011
Q:

I have a Craftsman chainsaw model 358360121. The fuel lines are rotted away. I am looking for a diagram showing how the lines run. Can you help?

A:

We don't have a diagram of how the fuel lines attach on the chainsaw. You don't have a choice on most connections because of the different size of the fuel lines. You have 2 small ports on the carburetor. If you reverse the lines the saw will start and run a few seconds and die. If this occurs reverse the 2 small fuel lines on the carburetor.

Read More
Jimmy K -
Sears Technician
Q:

I have a Craftsman chainsaw model 358360121. I need a diagram for new fuel lines. Sears.com has none. They referred me to you.

A:

We don't have a diagram for the fuel line connections on a chainsaw or trimmer. The technicians are trained on these things in factory schools.

You have one large fuel line and one smaller. This eliminates some chance for error. If you have 2 small fuel lines to the carburetor connect them and start the engine. Reversing the fuel lines will not prevent the chainsaw from starting. If you have them connected backwards, the chainsaw will start and die. Reverse them and you will be correct.

Read More
Jimmy K -
Sears Technician
March 04, 2009

Recommended maintenance parts & accessories

Show 3 more
No more item to show