Model #351217150 CRAFTSMAN lathe

  • Spindle/drive Assy
    3 Results
  • Headstock/bed
    3 Results

Question and Answers

Q:

Motor Wiring? 351217150 Craftsman Lathe

A:

The instructions for converting the motor to run on 220VAC power are shown on page 6 of the Owner's Manual.

I don't have information that will help you identify the L1, L2, L3 and L4 wires. The original labels on the wires identified them and I don't see any other way to determine which wire is which.

Read More
Lyle W -
Sears Technician
January 04, 2015
Q:

Lathe speed adjustment 351217150 Craftsman Lathe

A:

Thank you for your question.  I am sorry you are having a problem with the lathe. I looked up the model number you submitted. I am not tell from the parts image how the speed is adjusted. I know that the moveable pulley on the bottom has to be forced closed when sped up. I just cannot see the linkage that does that. I recommend looking at the linkage to see if it has an adjustment that will move the two halves together. If there is not an adjustment, look for worn parts that do not allow the pulley halves to come together all the way. I hope this is helpful. If you need further assistance, please reply below with images of the drive assembly and pulleys. I should be able to give you better advice once I see the set up. Thank you for using Manage my life. Mark

Read More
Mark T -
Sears Technician
February 17, 2013
A:

David, Please let me know if the parts take care of it. If you still have problems, you can email me pictures at mthoma21976@gmail.com. That is an account I have just for getting pictures. Just let me know if you send them because I do not check the account unless I know something is coming. Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
February 20, 2013
See more answers
Q:

Help on Craftman Lathe wiring issue

A:

Thank you for your question.

I can understand wanting to know how to hook up all the wires on the Lathe switch.

If the lathe is going to be running on 120 volts you would put 1 and 3 together and 2 and 4 together on the same terminals.

If you are switching to 220 volts 2 and 3 are isolated and not used.

Page 6 of the owner's manual shows this illustration.

I hope this was the information you were looking for.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
February 09, 2011

Top Parts