Model #3450 POULAN Chainsaw, Gas

  • Cylinder/flywheel
    3 Results
  • Cylinder Shield/tank And Handle Kit
    3 Results
  • Chain/clutch/bar
    3 Results
  • Carburetor #530069895 (hda-164)
    3 Results
Find part by diagram >

Question and Answers

Q:

How do I remove the front plate (fascia panel) off of a Bosch oven HBL3450CU? HBL3450UC02 Bosch Built-in oven, electric

Q:

Right pulley for different motor 113225900 Craftsman Sears belt and disc sander

Q:

need replacement capacitor for motor on table saw 113.299410 113299410 Craftsman Saw table

Q:

What is the amperage of the motor used on this model? 113242721 Craftsman Craftsman 9 inch motorized table saw

A:

Thanks for the inquiry and for being a valued member.

Based upon the part number for the motor of 62626, we show the specs as follows:

1 HP

3450 RPM

120 Volt

13 AMP

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
April 01, 2015
Q:

what is the hp rating on a motor with part# 31070.00

A:

Thanks for the inquiry and for being a valued member.

Based upon motor part number 31070.00, it is 1 3/4 HP with 3450 RPM. 

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
March 30, 2015
Q:

what is the rpm for the motor on this radial saw? 11323111 Craftsman Craftsman 10 inch radial saw

A:

Thank you for being Sears’ valued member and for contacting SearsPartsDirect.com with your question about your Craftsman radial saw model 11323111. I will be happy to help you with the rpm of the motor. In this case it is 3450 rpm. I located this information under the electrical connections in the manual. I have included the link below for you to view the manual online. 

I hope this answers your question. Thank you for choosing Sears, we appreciate your business. 
 

Read More
Rachel Morgan -
Sears Technician
February 17, 2015
Q:

looking for motor or substitute 113.226682

A:

Thank You for contacting ManageMyLife.com

I understand your frustration when trying to locate a replacement motor. The original motor is no longer available due to the age of the product. However, we do have 1 aftermarket motor that might work for you. You will need to check the specifications on your original motor to be sure this one will work for your saw.

Motor Specifications:

  • 2 Horsepower
  • 3450 RPM
  • 120/240 volts
  • 7/8” x 2-1/4 shaft
  • 3” x 4-7/8” base
  • Ball Bearing

If your motor matches these specifications then you can order it at the link below.

2 hp Aftermarket Motor

If your motor doesn’t match these specifications I have emailed you a coupon for the purchase of any new saw over $249

 

If you have further questions please let me know.

Thanks for using ManageMyLife.com

Read More
Desirea -
Sears Technician
October 19, 2013
A:

The motor on my saw gave up the ghost last night and I was looking for another motor. I clicked on the link that the Sears Expert provided and saw that the replacement motor is $850!!! That is enough to buy 4 or 5 used saws and more than 2 equivalent NEW ones! I think the coupon was the only correct solution here. I will see about having my motor repaired. Should be LESS THAN $150 which is the value of an equivalent used saw in good condition.

Read More
Charles -
December 03, 2014
A:

I have the exact same model - the only difference is that my motor still works, it just runs in reverse. Are there any other motor options other than the $850 dollar one? I can almost purchase a professional model for that price! This has been a great saw - and you just can't get one with the same surface area for a reasonable price any longer. Also - if it is possible to fix it for less than the cost of a new one, I am looking for a replacement fence - preferably something that works a bit better than the original. The person I spoke to on the chat feature wasn't able to help me with that either. Any ideas?

Read More
William -
February 04, 2015
See more answers
Q:

kenmore water distiller

A:

I understand your concern toward wanting to clean your water distiller to that you will have cleaner water. While you are waiting for an expert answer, I did manage to find a link in where you can enter your model number and a parts list diagram will pop up. As for maintenance I would look in your owners manual, below is a second link in where you can also enter your model number and your owners manual will pop up. I hope my links are useful.

Read More
Joseph P. -
October 13, 2010
A:

The information Joseph P sent answers your question. I am sending some information also.

You can order the charcoal filter from [www.searspartsdirect.com&MML=MMLxexpertxmerch]. The part number for the filters is 3454109, and the cost is $9.99 for a package of 4 filters.

The best way to clean the reservoir is to put a mixture of half and half vinegar and water in the reservoir and turn the distiller on. This will make a strong vinegar odor and might be best done outside.

Read More
Jimmy K -
Sears Technician
October 16, 2010
A:

Thanks while waiting for an answer I tried the old vinegar cleaning trick for coffee pots. I just left it in the reservoir till it disolved and then rinsed. Thank you for your help and I will order the filters. I tried to find the owners manual but was unsuccessful so I tried you. Thank you again.

Read More
Anonymous -
October 16, 2010
A:

I, myself, use CLR (from hardware store, or cleaning section of grocery store). Put about a tablespoon of it in. Let it sit for about five minutes. Roll it around the sides, too.

Read More
Kevin -
January 24, 2015
See more answers
Q:

electric motor horsepower

A:

240 volts and 7 amps as per the owners manual would yeild an approx HP Rating of 1.464. The Owners Manual which you can download at the link below was printed in "73".

Read More
Anonymous -
October 18, 2012
A:

Thank you for the info.

Read More
Anonymous -
October 18, 2012
A:

Thank you for your question on the horsepower rating of the direct drive motor on the table saw.

This motor was similar to the radial arm saw motors that the Emerson electric motor division built as proprietary motors only used on the special products division of the Emerson tool company for the Craftsman tool line.

I believe most of these motor were rated 3 hp peak which actually is 1 1/2 nominal horse power.

This model was 220 volts only at 3450 rpm and 7amps.

Most of the parts are no longer available but if you can tell me what you think you need I will see if it is available.

Sam A.

Read More
Sam A -
Sears Technician
October 19, 2012
A:

Thank you. I am in need of a fence lock , part number 62073 and complete saw guard assembly , part number 62398. These parts are for a craftsman 12 in. floor saw , model number 113.299131. Marv

Read More
marvin -
October 26, 2012
A:

Thank you Marvin for your parts replacement request, but most of the parts that make up the guard assembly and the fence lock are no longer available for purchase as replacement parts. Neither the complete guard assembly nor the some of its parts that make up the guard are no longer available. I am sorry that I cannot help you with your parts request. Sam A.

Read More
Sam A -
Sears Technician
October 26, 2012
A:

Thanks for trying to help. Marv

Read More
marvin -
October 26, 2012
A:

Is it possible to convert this saw to a belt drive? That is, without going to great trouble and expense?

Read More
David -
April 14, 2013
A:

I need to know how to wire the start and run capacitors... I ordered replacements and by the time they arrived I had forgotten how they were wired!

Read More
KIRISTIAN -
January 18, 2015
See more answers
Q:

air compresser pressure 919.176841

A:

Thanks for your question- we see that no one from the community responded.  If you still require assistance on this topic, please resubmit your question with any updated information and we will have one of our experts take a look.  Also, we have updated our site to include information regarding common repairs and diagnosis, which can be found here: www.searspartsdirect.com/repair-help.html.  If you are looking for your owner’s manual, it can be found here: http://www.searspartsdirect.com/partsdirect/user-manuals.  Thanks for visiting SearsPartsDirect.com.

Read More
Sherman_G_Wallace -
Sears Technician
May 14, 2014
A:

Hello I have purchased the same air compressor. Can you tell me if you have successfully wired your motor for 120 volts? And how did you do it?

Read More
Matthew -
December 22, 2014
A:

my compresor doesen`t build up preasure. what is the problrem with it

Read More
mark a -
December 24, 2014
See more answers

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show