Model #331777-1372-B2 Briggs & Stratton engine

  • Cylinder/crankshaft/crankcase
    3 Results
  • Head-cylinder
    3 Results
  • Carburetor
    3 Results
  • Blower Housing
    3 Results
  • Motor Starter/alternator
    3 Results

Question and Answers

Q:

How much will it cost me to have a new engine installed in my Tractor (20 H.P.) ?

A:

Thank you for your question.

I am sorry you are having a problem with the tractor. I have looked up the model number you have submitted. The replacement engine for the tractor is part number 331877-3036-G5 and can be ordered from our parts website. 331877-3036-G5. The cost of the engine is $ 768.15. I am sorry I cannot give you the cost for labor because the technician would have to give an estimate on that. You can call 1-800-469-4663 to schedule service.

Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
September 22, 2011
Q:

Repair manual

A:

Thank you for your question and I understand your concern.

Without having the complete model number of the mower and a complete model number of the engine, I will not be able to confirm if there is service manual available or not.

I did find a service manual for the Briggs and Stratton model 331777-0946-B1 engine in the parts list under the engine model number.

 I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

Read More
Joey S -
Sears Technician
July 15, 2013
Q:

Hi, I have a Kenmore 110.94832201 gas dryer that will not heat. There are no error codes present and it tumbles and runs, but it does not heat up.

A:

Make sure that you have an adequate gas supply provided to the dryer and that the exhaust vent duct system is clear.

Your details indicate that you have performed some extensive checks. The wiring diagram for this dryer is shown in the image below with the heating circuit traced in red. The readings that you provided indicate that the components are okay. The resistance variance on the one valve coil should not prevent the gas valve from opening. I recommend that you start the dryer with that bottom front service panel removed and see if the igniter glows when the dryer is running in a heated cycle. Do not make contact with any internal wires or components when running the dryer with internal components exposed. If the igniter is glowing, this indicates that you are getting voltage from the heater relay on the machine control board and that the igniter is probably okay. If that igniter is not glowing, I recommend that you unplug the dryer and check the resistance of that component. The igniter should measure between 50 and 240 ohms. If the igniter is "open" (measure Ol -- open load or infinite resistance) then it will need to be replaced. If the igniter is okay, then you probably have a wiring failure or a bad heater relay on that control board.

You can order parts from the Sears PartsDirect website.

These additional tips may help you resolve this dryer heating problem. If you need more assistance, reply with additional details and we will assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
June 23, 2011