Model #330-UT10604A Homelite chainsaw, gas

  • Figure 1
    3 Results
  • Figure 2
    3 Results
  • Figure 3
    3 Results
  • Figure 4
    3 Results
  • Carburetor Walbro
    3 Results
  • Carburetor Zama
    3 Results

Question and Answers

Q:

Is 330 and DV520agp the same?

A:

Thank you for your question.

I can understand wanting to know if the two different model dryers would be the same for changing the LP kit.

I am going to assume that the 330 model also starts with the prefix DV. Since they are both the DV series dryer designs you would access them the same way.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
March 11, 2011
A:

Thank you for the update. You are right the directions are not very clear as to how to remove the front panel. The way the pictures look is to remove the screws inside and below the door opening. With the top removed there are two screws on the top front inside that secure the front panel. Try to follow the images below. You will have to remove the burner assembly once you get the front panel off. The LP kit should have instructions on how to do the conversion. I hope this will help. Sam A.

Read More
Sam A -
Sears Technician
March 11, 2011
A:

Thank you for the update. If you look with the door open it looks like the screws are covered by the door. It also shows there are two screws at the top under the top panel. Some of the manufactures then want you to lift or pull on the front panel. They will either have a slide lock in the cabinet with hooks and you lift the panel to release. Or they will have frictions catches and you can pull on the front panel to break it loose. I am sure you are more than capable of doing this, and once we figure how to get the cabinet off for the first time it will be fine. As you say the instructions leave a lot to be desired. Sam A.

Read More
Sam A -
Sears Technician
March 11, 2011
A:

Thank you for the update. I will be here on saturday if you need help. Sam A.

Read More
Sam A -
Sears Technician
March 12, 2011
A:

I am sorry you are having so many problems with the laundry pair. Have you made sure both water valves are turned on? It sounds like it is not getting any cold water. We usually recommend that you have your LP gas provider to the conversion of the dyer. Have you contacted them or is that the technician that is coming out on Monday? Sam A.

Read More
Sam A -
Sears Technician
March 12, 2011
See more answers
Q:

Impluse line Part# 530069976 Model#330 Poulan Chainsaw 2800 Poulan 18" chain saw

A:

Thank you for your question. I will be happy to assist you. The impulse line on the saw activates the diaphragm in the carburetor. Which opens the needle valve to supply the engine with fuel. If the line is not connected, the engine will not run. The hose is connected to the carburetor on one end and the other is connected to the engine. The image below shows the line connected. Just click on the image to enlarge it. If you cannot see the image, click on this link.   I hope this is helpful. Please let me know if you need further assistance.  Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
February 26, 2013
Q:

Temp control on Elite Dual Fuel 40" range

A:

You can use the procedure shown in the image below to adjust the set oven temperature to match the actual oven temperature. That information is also in your owner's manual (page 36). Here is a link for the full owner's manual on that range: Owner's Manual .

If you need more help, reply with additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
January 16, 2012