Model #32-2757-00-05 TAPPAN Range (gas)

  • Cover Page
    3 Results
  • Cooktop Parts
    3 Results
  • Door Parts
    3 Results
  • Backguard
    3 Results
  • Drawer Parts
    3 Results
  • Burner, Manifold And Gas Control
    3 Results
  • Body Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

what does code f 05 mean

A:

The "F05" fault code indicates a Water Temperature Sensor Error. If during the water heating step in the wash cycle, the water temperature sensor (NTC) value is out of range, the "F05" error code will be displayed. See image below for further instructions.

Potential Causes:

  1. Check the Water Temperature Sensor resistance. It should measure 9.7K ohms at 86 degrees.
  2. Check connections to the Water Temperature Sensor
You will likely find the wire connection had come loose from the temperature sensor. Without having the model number of your HE3t washer I will not be able to confirm if the heater and sensor is located at the lower backside of the tub or at the front lower section of the tub. Disconnect the power cord from the power source before removing the front lower access panel and checking for loose connections on the temperature sensor.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
August 04, 2010
Q:

cast iron stove

A:

Thank you for your question and I understand your concern.
 
We do not have the manual but I found a web site and I found a discussion about an individual having the manual. You can likely get him/her to send it to you.
 
Follow the discussion on the web site to find the individual who said he had the manual. 
 
I hope this is helpful. 

Read More
Joey S -
Sears Technician
October 17, 2013
Q:

Craftsman lawn tractor -- engine seized

A:

Thank you for your question and I understand your concern.

Remove the spark plug and then see if the engine will spin over. If it battery and starter is okay and the engine will not spin over, then the engine very well could have seized up due to the lack of oil circulation when it was on the severe sideway incline.

It would likely cost less to replace the engine rather than having it rebuilt. I was not able to price the replacement engine. The parts list shows the replacement engine is part #311707-0028-E1.  I strongly suggest taking the mower in for an estimate of repair. It may cost less to have the engine replaced but I can't be certain. 

 If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link:Sears Home Services.

Read More
Joey S -
Sears Technician
April 18, 2013