Model #32-1019-00-05 Tappan range (gas)

  • Cover Page
    3 Results
  • Backguard
    3 Results
  • Cooktop Parts
    3 Results
  • Door Parts
    3 Results
  • Broiler Drawer Parts
    3 Results
  • Burner, Manifold And Gas Control
    3 Results
  • Body Parts
    3 Results

Question and Answers

Q:

Why would my whole house air cleaner not come on?

A:

Make sure that the access cover is closed. The air cleaner has an interlock switch that will prevent it from powering up if this cover is open.

I recommend that you shut off the circuit breaker and check the wiring and installation. I emailed you a PDF file with the installation instructions and other technical data in case you need it. NOTE: Some of this information is intended for technicians. Exercise caution when using this data. Follow electrical safety guidelines. Disconnect electrical power before accessing internal components.

The document that I sent you has a troubleshooting flow chart that may help you determine the cause of this failure.

If you need parts, you can order them from the Sears PartsDirect website.

If you do not feel confident repairing this problem yourself, then you can have it repaired by a Sears technician. Here is a link that will provide the nearest drop-off locations: Sears Home Services .

If you need more help, reply with additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
December 15, 2010
Q:

what does code f 05 mean

A:

The "F05" fault code indicates a Water Temperature Sensor Error. If during the water heating step in the wash cycle, the water temperature sensor (NTC) value is out of range, the "F05" error code will be displayed. See image below for further instructions.

Potential Causes:

  1. Check the Water Temperature Sensor resistance. It should measure 9.7K ohms at 86 degrees.
  2. Check connections to the Water Temperature Sensor
You will likely find the wire connection had come loose from the temperature sensor. Without having the model number of your HE3t washer I will not be able to confirm if the heater and sensor is located at the lower backside of the tub or at the front lower section of the tub. Disconnect the power cord from the power source before removing the front lower access panel and checking for loose connections on the temperature sensor.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
August 04, 2010
Q:

Craftsman lawn tractor -- engine seized

A:

Thank you for your question and I understand your concern.

Remove the spark plug and then see if the engine will spin over. If it battery and starter is okay and the engine will not spin over, then the engine very well could have seized up due to the lack of oil circulation when it was on the severe sideway incline.

It would likely cost less to replace the engine rather than having it rebuilt. I was not able to price the replacement engine. The parts list shows the replacement engine is part #311707-0028-E1.  I strongly suggest taking the mower in for an estimate of repair. It may cost less to have the engine replaced but I can't be certain. 

 If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link:Sears Home Services.

Read More
Joey S -
Sears Technician
April 18, 2013