Model #32-1012-00-01 Frigidaire free standing, gas

  • Cover
    3 Results
  • Backguard
    3 Results
  • Backguard
    3 Results
  • Cooktop Parts
    3 Results
  • Door Parts
    3 Results
  • Door Parts
    3 Results
  • Door Parts
    3 Results
  • Door Parts
    3 Results
  • Burner, Manifold And Gas Control
    3 Results
  • Burner, Manifold And Gas Control
    3 Results
  • Burner, Manifold And Gas Control
    3 Results
  • Burner, Manifold And Gas Control
    3 Results
  • Broiler Drawer Parts
    3 Results
  • Broiler Drawer Parts
    3 Results
  • Body Parts
    3 Results
  • Body Parts
    3 Results
  • Body Parts
    3 Results
  • Control Panel
    3 Results

Question and Answers

Q:

You did not answer my question. Go to the page and tell me which manual I use. Is it 00 or 01?

A:

I apologize for being clear. Use the manual or the 01 model.

Read More
Jimmy K -
Sears Technician
April 25, 2008
Q:

What is wrong when the igniter will glow for 10-12 seconds and then go off with out lighting gas?

A:

The most likely problem is weak solenoid coils on the gas valve assembly. There is always a chance that it's a failed gas valve assembly too. Key# 10 in the image is the gas valve assembly and key# 13 and 14 are the coils. It's recommended to replace both at the same time. I recommend ordering the coil kit which will include both coils. The part number for the coil kit is 279834.

I recommend calling a service technician to diagnose and repair your dryer.

Read More
Joey S -
Sears Technician
April 17, 2008
Q:

Interpreting Error codes on Bosch Washer WFMC2100UC/01 Bosch Washer WFMC2100UC/01

A:

The D:08 indicates that the motor speed sensor (tachometer) failed. The D:10 indicates that the power limiter switch tripped due to the motor being overloaded or binding up. The C:01 indicates that the codes were encountered the previous cycle in the last 16 washes. 

I recommend that you unplug the washer and check the drive system again for binding. You indicated that the drum spins freely by hand (I assume with the drive belt attached to the motor). With the belt disconnected, the spin basket should spin even easier. Check for any binding or noise in the spin basket with the belt detached. The basket may not be spinning easily with a load of wet clothes in the basket.

If you find no problems in the drive system, then you may need to replace the motor.

I hope that this information helps. If you need further assistance, let us know.

 

Thanks for choosing Sears PartsDirect.

Read More
Lyle W -
Sears Technician
March 12, 2015