Model #31AE295-063 Troybilt snowthrower, gas

  • Wheels/chute/shroud/handle
    3 Results
  • Engine/gas Tank
    3 Results
  • Handle
    3 Results
  • Chute
    3 Results

Question and Answers


replacing walking belt on treadmill


Thank you for your question.

Replacing the belt on your treadmill is fairly difficult and time consuming. In addition, there are no really detailed instructions for replacing it since a professional would typically do that type of service. We do not have a treadmill service manual that shows how to replace the walking belt.

The basic instructions are listed below to help you.

  1. Unplug the treadmill from the power source.
  2. Remove the motor hood on the front of the treadmill.
  3. Remove the right foot rail.
  4. Remove the rear roller adjusting bolts.
  5. Remove the front roller adjusting bolt. Make sure to count the number of turns it takes to remove the bolt. Then when you reinstall the bolt, you can get it in the same place.
  6. Remove the front roller.
  7. Remove the screws from the right side of the walking board. Then lift the walking board and slide the walking belt off the board.
  8. Reverse the instructions to reassemble the treadmill.
  9. Before installing the motor hood carefully check the operation. The drive belt might need to be adjusted.
I have added the instructions for adjusting the walking belt below. Again, this is a fairly involved repair, so if you have any concerns or reservations you may want to consult a professional.

I hope this is helpful. Please reply below if you need further assistance. Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
October 22, 2011

Joyce, Some treadmills have a spring and nut on the end of the bolt. If you could please reply below with the model number, I will be happy to look up your model. Once I can see your model I will be able to give you the correct information. I hope to hear from you. Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
June 05, 2013
See more answers