Model #31A-150-000 Mtd snowthrower, gas

  • Handle Assembly Control
    3 Results
  • Body-lever Control
    3 Results
  • Auger Assembly Comp.
    3 Results
  • Wheel Assembly
    3 Results
  • Crank Assembly Chute
    3 Results
  • Crank-chute-lower-upper
    3 Results
  • Choke Cover
    3 Results
  • Fuel Tank
    3 Results
  • 16" Fuel Line Hose
    3 Results
  • 2 Qt. Fuel Tank
    3 Results

Question and Answers

Q:

kenmore ultrasoft 150 water softner,

A:

Carol,

The water softener should have about two inches of water in the bottom of the salt tank. If there is more than that in the salt tank, I recommend cleaning the nozzle venturi first. I posted an image below that shows how to clean the nozzle venturi. Then remove the cover of the brine well on the right side of the salt tank. You need to be sure the float assembly is pushed down to the bottom of the brine well. If it is not, the water will be higher than normal. After it is clean, it could take a few cycles for the water level to get back to normal.

I hope this is helpful. Please let me know if you need further assistance.

Thank you for using Manage My Life!

Mark T.

Read More
Mark T -
Sears Technician
September 09, 2012
Q:

How old is my Craftsmen lawn mower?

A:

Thank you for your question.

This mower was produced 12/19/2003.

Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
May 18, 2011
Q:

Needing to reeplace shutters and speed control for Emerson whole house fan

A:

Thank you for your question.

I can understand wanting to get the whole house fan repaired so it will be a little cooler.

The parts supplier for you model of whole house fan is Carroll Parts.

Here is a link to there web-site with the phone number.

Carroll Parts .

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
June 20, 2011