Model #313-610E000 Mtd snowthrower, gas

  • Snow Throwers
    3 Results
  • Snow Throwers Page 2
    3 Results
  • Snow Throwers Page 3
    3 Results
  • Snow Thrower
    3 Results
  • Snow Thrower Page 2
    3 Results
  • Snow Thrower Page 3
    3 Results
  • Snow Thrower Page 4
    3 Results

Question and Answers

Q:

How do I dissemble my dryer and install parts?

A:

Thank you for your question and I understand your concern.

You should only need the part(s) that are broken or worn. Open the door and remove the screws along the bottom of the top panel. Hinge the top open and remove the screws securing the front panel to the side panels. Disconnect the power cord from the power source before servicing. 

I added an image below showing how to remove the front panel to access the top drum bearing. I can't confirm if the slide (key#316) will come with the new top drum bearing (key#313) or not. I would order it just in case. 

 I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. 

 

 

Read More
Joey S -
Sears Technician
April 30, 2013
Q:

What parts will I need to replace on my GE dryer to stop the squeaking noise?

A:

You dryer seems too new to have worn out slide bearings already. It could have a hard object stuck between the drum and slide or top bearing causing the screeching noise too. If there is no objects or debris found possibly causing the noise then the most likely cause of the squeaking/screeching noise is worn drum slides (key#315&316) and possibly the top bearing (key#313). The drum also has sleeve bearing (key#3106) located on the rear of the dryer which is inserted from the inside out. The drum shaft fits through the sleeve bearing (key#3106) and it has also been known to make a screeching noise.

Read More
Joey S -
Sears Technician