Model #3106-3 BISSELL Vacuum, Upright

  • Stick Vac
    3 Results
Find part by diagram >

Question and Answers

Q:

Kemore Elite 3106 slide-in gass stove

A:

Thank you for your question and I understand your concern.

I added a link to the Installation Instructions with the cut out specifications.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
April 27, 2012
Q:

31as644e129/3

A:

Thank you for your question.

I am sorry you are having problems with the snow blower. The model number you have provided did not pull up for me but that is ok, the information is going to me the same. If the auger is not turning, I recommend checking the belt first. The instructions for adjusting and replacing the belt should be in the owner's manual. If the belt seems to be fine start the engine and have, someone pull the auger lever while you watch the augers from a safe distance. If the impeller is spinning and the augers are not I recommend checking the shear bolts. The shear bolts are made to break if the auger comes into contact of something hard. The second image shows how to replace the shear bolts. If the shear bolts are ok, the problem would be a sheared gear in the front gear box. To replace this gear you have to completely disassemble the front of the snow blower. A service technician usually does this type of repair. I hope this is helpful.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
January 23, 2011
Q:

Err 3

A:

Thank you for your question on the high water level in the water softener.

If sounds like the venturi passage is plugged or the rotary valve is jammed in a cycle.

You will need to unplug the softener and remove the salt and water from the storage tank.

Then you will need to check and clean the venturi as described on the under side of the lid of the softener cover. Also check the wire harness connections for the control board and the position switches for the rotary valve.

If it is stuck in the fill position you can tell be looking in the small window on the top of the valve to see in want position the valve is currently in.

If the normal operation of the valve an S for service should be in the window of the valve frame. If it is in any other position the valve may be jammed and is too hard for the motor to rotate the valve.

If this is the case you may need to remove the valve rotor and replace the seal and gasket kit for the softener.

I will give you a link to troubleshooting for Kenmorewater.com and this will help you understand the operation of the softener.

Kenmore water troubleshooting information .

I have given you the error code definitions below.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Please let me know what you find out and if you further assistance please let me know.

Sam A.

Read More
Sam A -
Sears Technician
August 14, 2012