Model #30-2528-00-02 TAPPAN Range (gas)

  • Cover Page
    3 Results
  • Backguard
    3 Results
  • Cooktop Parts
    3 Results
  • Door Parts
    3 Results
  • Broiler Drawer Parts
    3 Results
  • Burner, Manifold And Gas Control
    3 Results
  • Body Parts
    3 Results

Question and Answers

Q:

Why is my timer hard to turn?

A:

The washer timer knob assembly and timer will most likely need to be replaced since the alignment pin corroded off.

The timer knob (key#30) should thread ON and OFF of the threaded timer shaft. Over time and use, the timer can become hard to rotate and eventually cause the timer knob assembly to break or the alignment pin.

I recommend calling a service technician to diagnose and repair your washer.

Read More
Joey S -
Sears Technician
Q:

I am getting a F7 02 code on my kenmore electric range model # 790.4661. I have read many of the questions and answers but still need help.

A:

I understand your concern and since you have already replaced the Oven Control/Clock Timer and it' still displaying the fault codes we can assume the failure is likely the touch panel.

The "F701" fault code is likely caused by a loss of a keyboard tail connection.

The "F702" fault code is likely caused by a shorted keypad.

Since the Electronic Oven Control (EOC) has been replaced, the failure is likely the Glass Touch Panel providing you do not have a loose keyboard tail connection.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services

Read More
Joey S -
Sears Technician
November 18, 2010
Q:

what is error code F 02 mean

A:

Thank you for your question and I understand your concern.

The "F02" fault code displays when the drain time exceeds 8 minutes. This can happen if the drain pump filter is restricted or if there is too many suds due to the wrong type of detergent being uses or too much detergent being used.

I added an image below showing how to access the drain pump filter. NOTE: Be sure to have all the water removed from the tub before removing the drain pump filter. You will also need to disconnect the power cord from the power source before removing the front lower access panel.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
July 05, 2011