Model #30-1049-23-08 Tappan range (gas)

  • Cover Page
    3 Results
  • Backguard
    3 Results
  • Burner Parts
    3 Results
  • Body Parts
    3 Results
  • Cooktop And Broiler Drawer Parts
    3 Results
  • Door Parts
    3 Results

Question and Answers

Q:

We purchased a 30" gas freestanding LG double oven which was delivered on 2/23/13.

A:

I am not aware of any problems or common issues with that model of LG double oven. You are probably correct about the noise being caused by metal contracting. Since the oven is brand new, you may consider having a service technician examine it. The technician can check for any potential problems while the oven is still under warranty.

Read More
Lyle W -
Sears Technician
April 24, 2013
A:

Based on your description, I recommend that you have a service technician examine the range under the warranty. Based on that recommendation, you should not be charged for service if the technician finds that the noise is normal and nothing is wrong. Let the phone agent know that we recommended the service call and the will set up the warranty service. You should not have to worry that you will be charged anything based on my recommendation. If you need more help, let me know.

Read More
Lyle W -
Sears Technician
April 24, 2013
See more answers
Q:

Expert Joey S.. I looked up parts number .. doesnt existed

A:

Thank you for your question and I understand your concern.

I double checked the part number of the Bake ignitor (5303935066) and it is a good part number. You can order from SearsPartsDirect . Click on the link and will take you to directly to the page. It will list 4 of the same part numbers. It will be a universal ignitor that will fit many different models.

Read More
Joey S -
Sears Technician
July 27, 2011
Q:

What would cause my dryer to take 2-3 cycles to dry?

A:

First, if your dryer is an electric dryer and not gas remove the vent hose from the rear of the dryer and dry a load. If it dries the clothes in one cycle normally that would indicate a venting issue. Open the door and remove the lint filter and check for a blockage down in the lint filer housing. Inspect the lint filter, take the filter and run water over it to see it the water will pass freely through it. If you use fabric softener it will leave a clear layer over the little holes and restrict the airflow. Take the lint filter and wash it off with water and a brush. Use a vacuum to clean the lint out. Any airflow problem will cause the dryer to take longer to dry. If it's a gas dryer it could have weak gas solenoid coils and it's not always opening the gas valve.

If you’re confident that there are no air flow restrictions I recommend calling a service technician to diagnose and repair your dryer.

Read More
Joey S -
Sears Technician
July 16, 2008