Model #2987-MILLING ATTACH. Craftsman lathe accessory

  • Unit Parts
    3 Results

Question and Answers

Q:

How do I attach the grass catcher?

A:

You are correct, the bagger connects to the side discharge on this mower.

I am sending you the page from the owner's manual that shows how to attach the bagger to the discharge chute on the mower deck. It seems to me the instructions are vague. If you have the bagger, put it beside the mower and remove the mulch plate. You can probably figure out how to connect the bagger to the deck.

You can download or print an owner's manual at [www.managemylife.com].

Read More
Jimmy K -
Sears Technician
March 15, 2009
Q:

Where & what does the throttle link attach to?

A:

The throttle link attaches to the throttle plate on the carburetor. There are only 2-3 holes in the throttle plate, try them until you get it right. We don't have any pictures of connecting the throttle linkage to the carburetor.

Read More
Jimmy K -
Sears Technician
May 28, 2009
Q:

How does the helix-auger attach to helix-lock plate?

A:

I added a image to reference in the image below.

The helix lock plate (key#356) is held onto the end of the helix auger (key#350) with a c-clip (key#321). The auger motor drive (key#365) couples to the cup drive (key#355) which spins the auger (key#350) which drives the helix lock plate (key#356) which then drives the helix (key#357). The helix lock plate has a slight bend or bow so it will fit down in the recessed area of the helix in order to turn the helix. The tension of the lock plate keeps each end locked in the cut out portions of the helix. NOTE: The image is a little misleading as to the order of the parts.

Read More
Joey S -
Sears Technician
July 14, 2009