Model #270-SUA Mtd engine

  • Muffler
    3 Results
  • Shroud Engine
    3 Results
  • Short Block/crankshaft
    3 Results
  • Cylinder Head
    3 Results
  • Carburetor
    3 Results
  • Flywheel
    3 Results
  • Fuel Tank
    3 Results
  • Electric Starter
    3 Results

Question and Answers

Q:

Not firing. FPSH 50 270

A:

I recommend that you have a service technician examine and repair that appliance. You could have a gas valve problem or an issue with ventilation.

Read More
Lyle W -
Sears Technician
November 04, 2013
Q:

My Kenmore washer..Model # 110 270 42603

A:

Hi Betty,

Thank you for submitting a question to Manage My Life.

The F1 fault code on this washer indicates that the water level pressure transducer signal is out of range. The pressure transducer air hose tubing being pinched or crimped can cause this. A failed pressure transducer on the machine control board can also cause it.

The first image below shows the method for accessing the pressure transducer tube that runs from the bottom of the washer tub to the machine control. I recommend checking this air hose for pinches, twists or crimps. Always unplug or de-energize electrical equipment before removing covers or attempting service. Be careful and wear appropriate hand protection when working around sharp metal parts.

If you find no problems with the pressure transducer tube, then the machine control board will need to be replaced. The procedure for accessing and replacing the machine control board is shown in the second image below. The part number for the machine control board is W10189966.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website; Sears Home Services .

Here is a link that you may use to purchase the Control Board for your Kenmore model number 110.27042603 .

I hope this is helpful. Check the things I have covered here and if I may be of further assistance please reply to this post.

Landell

Read More
Landell -
Sears Technician
July 23, 2012
Q:

SEARS/MTD 357CC SNOW THOWER ENGINES MODEL NUMBER 483-SUA

A:

Thank you for your question.

I have looked up the model number you have submitted. The engine is made by MTD. They purchased this plant a few years ago and are now making the for most MTD made products. The engines seem to be holding up well. Really, the only problems we have is with the carburetor. The cause of the carburetor problem is because the fuel used in the product usually is not treated with fuel stabilizer.

I hope this is helpful. Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
December 03, 2011