Model #270-QU Mtd engine

  • Electric Starter
    3 Results
  • Carburetor
    3 Results
  • Crankcase/crankshaft
    3 Results
  • Head Cylinder
    3 Results
  • Control Panel
    3 Results
  • Recoil Starter
    3 Results
  • Muffler
    3 Results
  • Fuel Tank
    3 Results

Question and Answers

Q:

Not firing. FPSH 50 270

A:

I recommend that you have a service technician examine and repair that appliance. You could have a gas valve problem or an issue with ventilation.

Read More
Lyle W -
Sears Technician
November 04, 2013
Q:

My Kenmore washer..Model # 110 270 42603

A:

Hi Betty,

Thank you for submitting a question to Manage My Life.

The F1 fault code on this washer indicates that the water level pressure transducer signal is out of range. The pressure transducer air hose tubing being pinched or crimped can cause this. A failed pressure transducer on the machine control board can also cause it.

The first image below shows the method for accessing the pressure transducer tube that runs from the bottom of the washer tub to the machine control. I recommend checking this air hose for pinches, twists or crimps. Always unplug or de-energize electrical equipment before removing covers or attempting service. Be careful and wear appropriate hand protection when working around sharp metal parts.

If you find no problems with the pressure transducer tube, then the machine control board will need to be replaced. The procedure for accessing and replacing the machine control board is shown in the second image below. The part number for the machine control board is W10189966.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website; Sears Home Services .

Here is a link that you may use to purchase the Control Board for your Kenmore model number 110.27042603 .

I hope this is helpful. Check the things I have covered here and if I may be of further assistance please reply to this post.

Landell

Read More
Landell -
Sears Technician
July 23, 2012
Q:

The mower blades on my Craftsman lawn tractor, model 917 270 752, will not disengage. The clutch lever is difficult to move.

A:

You might need to replace the cable clutch on the tractor.

Lower the deck to the lowest setting and do not start the engine. Move the idler bracket the clutch cable is attached to. It should move fairly easily with your hand. The idler bracket might need cleaning and lubricating.

Disconnect the clutch cable from the idler bracket and move the deck engagement lever with the clutch disconnected. If the lever is still hard to move, replace the cable clutch.

Read More
Jimmy K -
Sears Technician
April 19, 2010