Model #264 Bolens walk behind lawnmower, gas

  • 22" Self-propelled Mower
    3 Results

Question and Answers

Q:

washer spin cycle?

A:

Thank you for your question and I understand your concern.

Your model washer does not use a drive belt. Your washer is a direct drive washer. It uses a motor coupler to link the motor to the transmission. The part that you think is a stretched belt is nothing more that a sound deadener that is stuck onto the outside of the brake housing to prevent the housing from resonating (making noise) when the brake engages.

If your washer operates in the spin cycle and it's not spinning or spinning well but agitates then it may need a new clutch. The clutch is part #285785 and can be ordered from Sears PartsDirect .

If you feel confident in replacing the clutch, I added a YouTube video showing how to access and replace the clutch .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
September 14, 2011
Q:

Why did water keep filling the ice maker in my Kenmore refrigerator model 106.74252402?

A:

According your symptoms, the water valve assembly (part number 2188808) will need to be replaced. You can order this part from the Sears PartsDirect website.

The normal resistance of each solenoid is about 300 ohms. The resistance of the dispenser solenoid was close to this value and was working properly. Since the resistance of the ice maker solenoid is only 2.2 ohms, it is apparent that this valve is bad. It is difficult to predict why it stuck open and overfilled the ice maker mold. It is possible that the water flow kept the valve open. When water flow and pressure was removed, the valve apparently shut. Since the solenoid is bad and will not open the valve, it will need to be replaced. This will likely fix your ice maker problem.

It is unlikely that the ice maker module caused the failure of the solenoid valve. The ice maker module simply applies voltage to the ice maker water solenoid valve through the tan and white wires during the cycling process. I provided the technical information regarding the ice maker module in the images below. If needed, you can use this information to test the ice maker module. This information is intended for technicians. Extreme caution should be exercised when using this information. Follow electrical safety guidelines and unplug the refrigerator when accessing internal components. Do not attempt any test (including using the insulated jumper wire to manually cycle the ice maker) unless you are completely confident in your technical ability to safely complete the test. Leaving the jumper wire in the module for too long can cause damage to the ice maker. Carefully read and follow that procedure if you use it.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
July 09, 2009
A:

Hello Phyllis. You could have problem with the fill valve or a number of other problems. I added a link for a good video that shows technical information and troubleshooting for the type of ice maker that you probably have in your refrigerator. That information may help you diagnose and repair that failure. If you need more assistance, let us know.

Read More
Lyle W -
Sears Technician
April 21, 2012
See more answers

Recommended maintenance parts & accessories

Show 3 more
No more item to show