Model #25865-4A KENMORE ELITE Grill, Gas

  • Gas Grill
    3 Results
  • Rotisserie Assembly
    3 Results
  • Hardware Pack Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

How do I properly attach the grass catcher model 917.248911 on my Craftsman lawn tractor model 917.28903?

A:

According to your description, you will need to attach the support plate shown in Figure 4C of the grass catcher instructions. This should help you secure the grass catcher properly.

Read More
Lyle W -
Sears Technician
September 08, 2009
Q:

Kenmore Dehumidifier 580-54701500

A:

Try running the unit at the 35% level and see if it runs more constantly. If the unit runs properly at that level then it is probably working normally.

If the unit is not collecting any water and the compressor kicks off after only running 30 to 40 seconds after starting every time, then you could have a bad compressor. A service technician would need to fix that type of problem. If the dehumidifier is less than 5 years old, the sealed system should still be covered by the warranty. Refer to your owner's manual for details about that warranty. Barbara H. posted a link for your manual in the above response in case you need it. Here is a link for the Sears Service website that lists drop-off locations in case you need it: Sears Home Services .

I provided the information about accessing the components in this dehumidifier in the image below. I also provided a wiring diagram for the unit. This information may help you access and connect the wires on that main control board (KEY 4a). Be sure that you unplug the dehumidifier before accessing internal components.

If you need more help, reply with additional details.

Read More
Lyle W -
Sears Technician
July 16, 2011
Q:

Kenmore Infinity Switch Hookups

A:

You are correct about the connections on the right rear burner switch. The P will be connected to the 2-P. The H1 wire will be connected to the 1-H1, etc. The locations of those terminals on the new switch are in different locations but the terminals are labeled the same on the 2nd switch except for the additional number in front.

The part number that you have for the right front burner switch does not appear to be correct. You indicate that you have part 316049800. My records indicate that you should be using part number 316238200 for that right front burner switch. That part number 316238200 switch should have the same designations as the original switch (P1, P2, 2, 4 and 4a). I recommend that you exchange or return that part 316049800. It does not appear to be the correct burner switch for that right front burner.

You can order that burner switch part 316238200 from this page: Right Front Burner Switch for Kenmore Range Model 790.92680302 .

I hope that this information helps. If you need more assistance, reply with additional details.

If you get to the point where you need to have a service technician replace those burner switches, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
December 03, 2012
A:

Dan: Based on the image of the new switch, it looks like you do not have the correct switch. If you would provide the complete model number of your range I can then check for the proper part number for the left front burner switch.

Read More
Joey S -
Sears Technician
July 26, 2013
A:

Dan: It seems you have the wrong switch according to the parts image at Searspartsdirect. This would expain the extra terminals. Key#54B should be part #316049800.

Read More
Joey S -
Sears Technician
July 29, 2013
See more answers