Model #24616-RST5.6 HORIZON treadmill

  • Treadmill
    3 Results

Question and Answers

Q:

treadmill lift does not work

A:

The link for a previous answer provided by James R. in the above response should help you with the troubleshooting of this incline problem. I provided a wiring diagram and other information for this treadmill in the images below that may also help. Unplug the treadmill and check the wiring connections first. If the wiring connections are okay, then there is a good possibility that you have a failed incline motor since it is getting hot but not working properly. If you are completely confident in your technical ability to safely check the live voltages shown in the first image, you can see if the motor is getting the proper current before replacing the motor. If you need more help, reply with additional details and we will assist you further.

You can order parts from the Sears PartsDirect website.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
December 08, 2010
Q:

The circuit breaker on my treadmill keeps popping off. This is a new thing on a four yr old treadmill. Any ideas?

A:

I suspect the walking belt on your treadmill needs lubrication. You should only use the special lubricant recommended for the treadmill.

You can order the lubricant kit, which consists of 3 tubes of lubricant with applicators and instructions for applying. The part number of the lubricant for the walking belt is 219170 and the cost is around $30.00.

Read More
Jimmy K -
Sears Technician
March 16, 2010
Q:

This solution didn't work. Any other suggestions?

A:

I hoped the first answer I gave you would correct the problem. Next I would be sure the treadmill is getting 110-120 volts ac. If there is any doubt, move the treadmill and connect it to a different circuit.

If the voltage is ok, I would replace the circuit breaker. Sometimes circuit breakers fail.

Read More
Jimmy K -
Sears Technician
March 26, 2010