Model #23352363200 Kenmore range hood

  • Range Hood
    3 Results

Question and Answers

Q:

my kenmore elite range hood 23352363200 fan motor not turning properly. where do i disconect wires to add new motor

A:

Thank you for your question and I understand your concern. First, disconnect the power supply by flipping the house breaker off or disconnect the power cord.

The wires are connected to the Electrical system plate which is located under the bottom flue cover. Based on the image you supplied, you should see some type of box and cover to remove in order to access the electrical control board. Look for a cover, follow the wires and it should lead you to the control board. Disconnect the power cord before removing the lower flue cover.

Remove the lower flue cover and it will expose the electrical system plate where all the wires connect.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

To remove the motor:

1. Unplug the vent hood.

2. Disconnect the wires from the electrical system plate.

3. Remove wing nuts from the outside left and right sides under the flue cover.

4. Remove blower support by taking out 8 screws that are countersunk. DO NOT remove the 4 screws that are not.

Read More
Joey S -
Sears Technician
December 21, 2010
A:

I added a image below.

Read More
Joey S -
Sears Technician
December 21, 2010
See more answers
Q:

installing extnsion flue part 02258110991

A:

That replacement flue should be the same as the original one that you had installed. I see that Joseph P. posted the owner's manual/installation guide for your range hood in the above link. That information should help you install that extension flue. If you are still having problems after reviewing that information, reply with additional details and digital pictures of the problem if possible. We will try to assist you further once we receive more information.

Read More
Lyle W -
Sears Technician
May 24, 2012
Q:

my kenmore elite range hood 23352363200 fan motor not turning properly. i tore into it and find that when i hold it in vertical position it works

A:

Thank you for your question.

I can understand wanting to fix the vent hood yourself.

  • It sounds like the motor has bad bearings and when you put the motor on end the rotor shifts to a better spot on the bearings and runs ok. But that will not last very long and the only way is to replace the motor.

  • In the meantime you could use some turbine oil to lubricate the bearing to see if that will help.

The part number for the motor is;B02310187 and you can purchase it from;Sears Parts Direct .

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
December 20, 2010