Model #21A-645A711 TROYBILT Rear Tine, Gas Tiller

  • Tine Hood/handlebar
    3 Results
  • Driveshaft
    3 Results
  • Transmission Housing
    3 Results
  • Wheel Shaft
    3 Results
  • Bumper/wheel Assembly
    3 Results
Find part by diagram >

Question and Answers

Q:

How do I remove the knob and pointer from the washer timer on my Kenmore laundry center?

A:

In order to remove the washer timer knob will require accessing the back side of the timer. I added the instructions in the images below. NOTE: Disconnect the power cord from the power source before servicing the dryer.

Read More
Joey S -
Sears Technician
January 06, 2010
Q:

Circuit for Kenmore Elite Dual Fuel Range

A:

Thank you for your question and I understand your concern.

A 30 amp circuit will be needed for your dual fuel range. I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
March 05, 2012
A:

Mike: It's okay to use a power cord that is rated higher in amperage than to use a power cord with a smaller amperage rating. The power cord recommended in the installation instructions is a 125v/250v 30 amp power cord. There is no problem with using a cord that can carry 50 amps you just do not want to use one that is too small and can't carry the amperage draw. Below is the URL to the installation instructions. You can copy and paste the URL in your browser to view or download the installation instructions. http://www.managemylife.com/mmh/lis_pdf/INSTL/1103525L.pdf

Read More
Joey S -
Sears Technician
October 15, 2013
See more answers