Model #2175 TYPE 1-5 POULAN Chainsaw, Gas

  • Chassis/bar/handle
    3 Results
  • Shield/cylinder/crankshaft
    3 Results
  • Carburetor - Wt324 - #530069703
    3 Results
  • Service Reference
    3 Results
Find part by diagram >

Question and Answers

Q:

2700 PSI 5 in 1 Nozzle

A:

Thank you for your question on the pressure washer o-ring coming out of the nozzle.

Without the model number I can only give you some suggestions about the o-ring replacement.

You may have to replace the o-ring if it came out of its location or you could simply put it back into the nozzle for the mean time an then order some new replacement o-rings.

If this machine is new and under warranty I would suggest taking it in to be serviced before the warranty expires.

Please reply with the model number of the pressure washer and I will be glad to give you a more definitive answer.

I am thinking that it is model 580.752890.

Thank you for your comments and suggestions and I will pass this information onto the quality group.

Sam A.

Read More
Sam A -
Sears Technician
May 08, 2012
Q:

3 in 1 Lawn Tractor blade type

A:

Thank you for your question.

The 3 in 1 blade is used for mulching, bagging, and side discharge. We have used this blade for years and it work good for all 3.

I hope this is helpful. Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
May 15, 2012
Q:

wiring switch for 5 1/2 circular saw

A:

Thank you for your question on the wiring of the circular saw.

The switch number changes to a new substitute part number 606340-002.

If the new switch did not come with wiring instructions and because it is a different switch from the original I would suggest that you use a volt/ohm meter to the continuity through the switch from whether is has continuity from side to side or top to bottom.

Put your black probe on one of the terminals and the red meter probe on another terminal on the same side and pull the trigger to see if you get continuity.

Once you determine the connections in the switch then you can start with your black power cord wire to one side of the switch and the white to the other side. Remember this is a circle loop electrical circuit. The power comes from the cord into the switch and then into the motor windings and then out of the motor winding to the neutral side of the line back out of the power cord. The motor windings have to be between the hot and neutral on the power cord and the switch breaks or makes the circuit.

I am sorry but I could not find an appropriate picture to illustrate this for you.

Sam A.

Read More
Sam A -
Sears Technician
November 13, 2012