Model #2165-3 JAW Lather drill chuck

  • Unit Parts
    3 Results

Question and Answers

Q:

6inch vice jaw faces.

A:

Thank you for your question on the vise. This vise was made by Warren vise and it is now obselete.

I am sorry but I cannot verify that the part number you have given will fit that vise.

In recent years it has been very difficult to find replacement vise jaws because Warren is not longer in buisness. It was bought by Wilton and then Wilton was bought by Meir.

I am sorry that I cannot help you with the information as to if the part you found will work.

Sam A.

Read More
Sam A -
Sears Technician
July 11, 2012
Q:

replacement vise jaws

A:

Thank you for your question on the spacing of the jaws mounting holes.

When I put the numbers you gave me into the system they go back to the original number and it lists that the 51771-41 is a 2 1/2 in jaw.

I hope this will help.

Thank you for using Manage My Life.

Sam A.

Read More
Sam A -
Sears Technician
August 06, 2011
A:

I am sorry that you had a problem finding the jaw parts for the vise. Some of the manufactures will put the jaw faces on the parts list but when the manufacture goes out of business and no longer provides the replacement parts it is hard for the parts agents to find the parts. I am glad that you have the ability of make what you need. This is pretty much a lost art in this day and age. My grandfather was a blacksmith/farmer and we made most items we needed. Thank you and once again I am sorry for the wasted time with trying to find parts that are no longer available. Sam A.

Read More
Sam A -
Sears Technician
April 27, 2012
A:

Rex, Thank you for posting what you found. I am sure other users will find this helpful. I also wish we had the measurements for the jaws. Thank you for using Manage my life. Mark

Read More
Mark T -
Sears Technician
March 19, 2013
See more answers
Q:

3/8 corded drill

A:

Thank you for your question on the spindle being locked on the 3/8 corded variable speed drill.

I am sorry but we no longer have the manual available for you.

Also the manufacture does not have it in the archives so it must be a pretty old drill.

The spindle lock would have to be a mechanical lever or bar that you would have to release. I believe it may have been used for removing the chuck.

I would suggest opening the chuck all the way and then remove the center screw in the base of the chuck and unscrew the chuck from the drill. This may expose the spindle lock.

I am sorry but the parts image is so poor I cannot see any part that would be listed as a spindle lock.

If when you remove the gear box and the motor will spin then there has to be something in the gear box that is locked or seized.

Please let me know what you find.

Sam A.

Read More
Sam A -
Sears Technician
August 07, 2012
A:

Thank you for the update on the 3/8 drill. I think the gear is seized to the housing bearing if it will not come out easily. As I mentioned before the parts image is so poor I cannot see enough detail to see if there is anything holding the gear in place, but most of the time when you remove the housing you will find a retainer ring that is holding the gear to the housing. I would suggest looking down inside the housing to see if there is a retainer. You may have to remove some grease to see it. If not then as I said before that it may be seized into the housing bearing. Please let me know what you find. Sam A.

Read More
Sam A -
Sears Technician
August 07, 2012
See more answers