Model #20GV-5 LPG WILLIAMS Furnace- Wall

  • Replacement Parts
    3 Results
  • Blower And Rear Outlet Kit Replacement Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

improper flame on lpg dryer

A:

Thank you for your question and I understand your concern.

Based on your symptom it sounds like the pressure regulator and/or the LP orifice was not installed. The kit should have come with orifice and the blocking pin too.

I added a link below below with the instructions from a previous answer.

How to install the PCK 3100 LP kit?

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
July 06, 2012
Q:

LPG Dryer conversion

A:

Thank you for your question and I understand your concern.

I added an image below with the instructions for accessing the gas valve assembly. NOTE: Disconnect the power cord from the power source and also turn off the gas supply before servicing.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
October 22, 2012
Q:

convert dryer from lpg to natural gas

A:

Conversion of the dryer from LP gas to natural gas should be completed by a qualified installer.

To convert this dryer from LP gas back to natural gas, you will need the natural gas orifice (Size 44 -- part number 5303207410). If you did not save this orifice when the dryer was converted from natural gas to LP gas then you can order a new natural gas orifice from the Sears PartsDirect website.

The instructions used for the conversion of the dryer are shown in the first image below. The second image shows how to remove the bottom front service panel to access the burner assembly. The installer needs to unplug the dryer to disconnect electrical power and shut off the gas supply. The process for converting the dryer will need to be reversed using the LP conversion kit instructions as a guide. The blocking pin will need to be removed and the orifice will need to be changed back to the natural gas orifice (Size 44). The air shutter on the burner will likely need to be adjusted. The fittings will need to be properly leak checked. This information should help the installer properly convert the dryer back to natural gas.

I recommend that you use a pre-screened professional from the ServiceLive.com website if you do not already have a qualified installer to convert the dryer.

Read More
Lyle W -
Sears Technician
April 22, 2010