Model #19A Amana upright freezer

  • Model 12
    3 Results
  • Models 12a, 12a1, 12a2
    3 Results
  • Models 12b
    3 Results
  • Model 18
    3 Results
  • Model 18a
    3 Results
  • Model 18b, 18b1, 18b2
    3 Results
  • Model 18c
    3 Results
  • Models 12e, 12f, 12g, 12h, 15, 15a, 15b, 19, 19a, 19b
    3 Results
  • Door Assembly - Models 12e, 12f, 12g, 15, 19
    3 Results
  • Door Assembly - Models 12h, 15a, 15b, 19a, 19b
    3 Results
  • Shelf, Ice Cream Unit, Condensing Unit
    3 Results
  • Cabinet And Refrigeration
    3 Results
  • Door Assembly
    3 Results

Question and Answers

Q:

Craftsman Snow Thrower 536.885212 Put in New Carburetor, now too much throttle.

A:

Thank you for your question.

I am sorry you are having a problem with the snow blower. By what you have stated I suspect the governor has to be adjusted. I posted an image below that I highlighted the instructions for adjusting the governor. Click on the image to enlarge it. Once you have the governor adjusted start the engine and check the operation. If it still is too fast, you can adjust the speed. The image also has the instructions for adjusting the engine speed.

I hope this is helpful. Please let me know if you need further assistance.

Thank you for using Manage my life.

Read More
Mark T -
Sears Technician
January 10, 2013
A:

Thank you for your question.

I am sorry you are having a problem with the snow blower. By what you have stated I suspect the governor has to be adjusted. I posted an image below that I highlighted the instructions for adjusting the governor. Click on the image to enlarge it. Once you have the governor adjusted start the engine and check the operation. If it still is too fast, you can adjust the speed. The image also has the instructions for adjusting the engine speed.

I hope this is helpful. Please let me know if you need further assistance.

Thank you for using Manage my life.

Read More
Mark T -
Sears Technician
January 10, 2013
A:

Here is the image

Read More
Mark T -
Sears Technician
January 10, 2013
A:

George, please reply below with the model number of the snow blower. If it is the same as above, I recommend checking the third image. If it is different, look at the image below.

Read More
Mark T -
Sears Technician
January 10, 2013
A:

George, The third image above should match the engine you have on your snow blower. If you have any problems please let me know.

Read More
Mark T -
Sears Technician
January 13, 2013
A:

Gin, The reason the new carburetor does not have the push button drain is because the O-ring used to seal it would breakdown over time and leak. It was a great idea but did not hold up all that well. When you get ready to store the snow blower over the summer use a turkey baster to remove as much fuel as you can out of the fuel tank. Then place a pan under the carburetor and loosen the nut that secures the float bowl. This will allow the remaining fuel to drain. Once all the fuel is drained, tighten the nut and it is ready for storage. When you are ready to get the snow blower ready for winter, purchase a gallon of fresh gas and mix in the oil. You can pour this fuel in and test the operation. As long as you use fresh gas, it should be ok to leave it in the tank. Following these steps should eliminate the gumming up problem. Please let me know if you have any other questions or concerns. Mark

Read More
Mark T -
Sears Technician
January 13, 2013
See more answers