Model #190-425A-100 Agri-fab cart/dump cart attachment

  • Utility Carts
    3 Results

Question and Answers

Q:

What type of oil do I use for Craftsman Pressure Washer model# 580-750193

A:

Thank you for your question.

I am sorry but the model number you have submitted did not pull up for me. I do not want to give you information from a different model because not all the pressure washers use the same oil. The pressure washer has oil in the engine and the pump and they are different. Most engines use SAE30 motor oil. If you could please double check, the model number and specify if you need the information for the pump or the engine.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
October 04, 2010
Q:

range does not get higher than 100 degrees

A:

Thank you for your question and I understand your concern.

Based on your symptom and details, the high limit thermal switch has likely tripped during the high heat of the self clean cycle. The thermal switch is located on the back of the range and will likely have a red wire with a white stripe and a black wire with a white stripe connected to it. You will need to remove the range and take the rear panel off in order to access the thermal switch. There will be a red reset button in the middle of the thermal switch to push and reset. There are no video or written instructions. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

NOTE: Disconnect the range from the power supply before removing the back panel and resetting the thermal switch. I strongly suggest calling a service technician to diagnose why the thermal switch tripped.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
February 13, 2012
Q:

TEMPERATURE 100 DEGREES HIGHER

A:

Thank you for your question and I understand your concern.

If you're sure the thermometer you are using is accurate, you will likely need to replace the oven thermostat or just set the thermostat 100 degrees lower than need be. The oven temperature calibration adjustments are made by loosening the two screws on the back side of the thermostat knob and rotating the skirt. I added an image below with the calibration instructions.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
February 23, 2012