Model #15-3500A-WALL UNIT Dp misc exercise

  • Frame Assembly
    3 Results
  • Bench Assembly
    3 Results
  • Leg Lift
    3 Results
  • Preacher Curl
    3 Results
  • Base Assembly
    3 Results
  • Carriage Assembly
    3 Results
  • Leg Brace (with Pulley/cable Assembly)
    3 Results
  • Handlebar Assembly
    3 Results

Question and Answers

Q:

AC Wall Unit sweats inside a little.

A:

I suspect the main reason for the sweating is the extra humidity you are dealing with. Humidity makes the air conditioner work harder because it has to remove the heat and the humidity from the air.

You can probably reduce the sweating by running the fan at a higher speed on extra humid days. You might also direct the air flow in a different direction. Be sure the outlet air is not hitting a curtain, cabinet, or anything else that would cause some of the air to "bounce back" and go into the intake air.

Read More
Jimmy K -
Sears Technician
July 26, 2010
Q:

Wall Gas Oven unit not working.

A:

Thank you Greg, for the model number on the wall oven from the previous question you had asked.

I think you are the on with the F3 and F5 errors correct?

It sounds like you have replaced the most common failure on gas ranges with the igniter.

It could be the oven control relay contacts you are hearing as they open and close.

With the F3 it sounds like it could be the oven sensor circuit.

With the F5 that indicates that the relay on the electronic control board has failed.

If you have a multi-meter with an ohm scale you can check the sensor circuit.

A good sensor should be around 1050 ohms plus or minus 50 ohms at room temperature. You will need to remove the wire leads on the oven sensor and check across the wires to get the sensor ohm reading.

The relay circuit is part of the Electronic range control on this model and it sounds like it has failed.

After checking the sensor and you find it to be okay I would then consider replacing the control.

The part number for the control is: WB27T10268R for about $140.00 and it is a rebuilt because there are no longer any original replacement parts left for this control.

Thank you for using Manage My Life.

Sam A.

Read More
Sam A -
Sears Technician
August 09, 2011
Q:

kenmore microwave/oven wall unit

A:

You seem to asking about a component on the microwave of that wall oven/microwave combination. We recommend that you have a service technician diagnose and repair any microwave problems on that unit. Microwaves contain high-voltage components that can retain a lethal electrical charge of up to 2200 VAC -- even when the microwave is unplugged. Repairs and adjustments, even minor ones such as replacing components, can cause microwave leakage. A microwave shielding leakage test should be performed after any microwave service. It is for these safety reasons that we are unable to guide you in microwave repairs and instead recommend scheduling service with a qualified service technician. You can schedule service online with Sears Home Services or by calling 1-800-4-MY-HOME. We thank you for your understanding in this matter and hope we can help you with other questions and repairs in the future.

Read More
Lyle W -
Sears Technician
November 28, 2011