Model #153325541 KENMORE Water heater, Electric

  • Replacement Parts
    3 Results
  • Warranty
    3 Results
Find part by diagram >

Question and Answers


What would be the solution to get my romex wiring to reach the new replacement thermostat on my water heater?


The remedy would be to gain some slack in the romex power supply line so that it will reach the replacement thermostat. You will need to locate the strain relief clamp where the romex enters the water heater and loosen the clamp screws so that you can pull enough wire to reach the upper thermostat with high limit. There should be enough slack in the power supply line in order to gain enough length to reach the new replacement thermostat with high limit.

NOTE: Be sure to turn off the power supply to the water heater before servicing.

Read More
Joey S -
Sears Technician
October 03, 2008

Top Parts