Model #14-3700 Dp misc exercise

  • Unit Parts
    3 Results
  • Electronic Monitor
    3 Results
  • Frame Assembly
    3 Results

Question and Answers

Q:

Washer WLW 3700 BBLAD: How is the inner agitator removed?

A:

Thank you for your question and I understand your concern.

The inner agitator press fits over a rubber agitator coupler that is pressed into the top of the inner agitator. After removing the outer agitator you will have to pull the inner agitator up and off from the coupler. You can make a fulcrum using a 2X4 as shown in the image below. Route the rope under the bottom of the inner agitator and use the technique shown in the image below.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
August 13, 2012
Q:

Craftman 14 inch chainsaw

A:

We are not going to have that type of fuel line information for the chainsaw. The carburetor replacement is not intended to be performed as a do-it-yourself repair. If you examined and documented the placement of the fuel lines when you removed the original carburetor, then the fuel lines should normally be replaced in the same order on the replacement carburetor. Since the carburetor is a substituted part, it will likely be connected in the same manner. I recommend that you take the chainsaw into a Sears Repair Center and have a technician install the carburetor. Here is a link for the Sears Service website that has drop-off locations: Sears Home Services .

Read More
Lyle W -
Sears Technician
May 09, 2010
Q:

Craftsman 14" band saw

A:

To be sure we are talking about the same pins, I am speaking of the pins (item 50) on the parts diagram. These are locater pins and tight from corrosion over the rears.

Spray the pins liberally with rust buster and tap on the pins and the housing around them with a hammer to help the rust buster penetrate.

Clamp a pair of vise grip pliers on the pins and turn them slightly as you pull them out of the old housing.

Read More
Jimmy K -
Sears Technician
May 14, 2010