Model #14-3088-23-04 Tappan counter unit, gas

  • Cover
    3 Results
  • Cooktop Parts
    3 Results
  • Burner, Manifold And Gas Control
    3 Results

Question and Answers

Q:

Why is the ice maker leaking on my Kenmore refrigerator?

A:

According to your details, you indicated that the ice maker is leaking water on the floor when the unit is turned on. This symptom suggests that the leak is likely in the water tubing between the water valve and the ice maker module. I recommend unplugging the refrigerator and checking the water supply tubing from the water solenoid valve to the connection on the top of back outside refrigerator panel where it enters the freezer compartment. You will need to pull the bottom cardboard service panel off to access the solenoid water valve. If you find a leak in this water supply tube, then it will need to be replaced. This should fix your leaking problem.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
November 03, 2008
Q:

Any one with the same problem with samsung washing machine WF448AAP/XAA 04

A:

I researched that part. The bottom portion of that dispenser housing is only available as a complete dispenser housing assembly (part DC97-14522A). Here is a direct link for that part: Dispenser Housing for Samsung Washer WF448AAP/XAA 04 .

Read More
Lyle W -
Sears Technician
March 24, 2012
A:

Let us know if that part fits properly if you get the chance. Let us know if you need more help.

Read More
Lyle W -
Sears Technician
March 26, 2012
See more answers
Q:

What would cause my dryer to take 2-3 cycles to dry?

A:

First, if your dryer is an electric dryer and not gas remove the vent hose from the rear of the dryer and dry a load. If it dries the clothes in one cycle normally that would indicate a venting issue. Open the door and remove the lint filter and check for a blockage down in the lint filer housing. Inspect the lint filter, take the filter and run water over it to see it the water will pass freely through it. If you use fabric softener it will leave a clear layer over the little holes and restrict the airflow. Take the lint filter and wash it off with water and a brush. Use a vacuum to clean the lint out. Any airflow problem will cause the dryer to take longer to dry. If it's a gas dryer it could have weak gas solenoid coils and it's not always opening the gas valve.

If you’re confident that there are no air flow restrictions I recommend calling a service technician to diagnose and repair your dryer.

Read More
Joey S -
Sears Technician
July 16, 2008