Model #137248480 CRAFTSMAN Saw Table

  • Table
    3 Results
  • Base
    3 Results
  • Motor Assy
    3 Results
  • Stand
    3 Results
  • Motor Breakdown
    3 Results
Find part by diagram >

Question and Answers

Q:

craftsman 10 in table saw

A:

Thank you for your question on the adjustment of the blade.

I am not sure exactly what you are asking for. I am going to need a little more detail as to what you want to do with the blade.

Are you looking for the instructions on getting the blade square with the miter slot on the table or raising and lowering the blade?

If you are need to square the blade with the table then on page fifteen of your owner's manual goes through the steps of doing that adjustment.

At the back of the abor housing there should be a pair of lock nuts and set screws you can use to adjust the blade left and right with.

If you need more information please reply and I will be happy to help you.

Sam A.

Read More
Sam A -
Sears Technician
January 17, 2012
Q:

Dado Molding Insert 137248480 Craftsman Table saw

A:

Thank you for your question on the dado blade table insert for your table saw.

I will give you the parts information you need below in the link.

Dado blade table insert for model 137.248480 .

I hope this will help you.

Sam A.

Read More
Sam A -
Sears Technician
October 17, 2012
Q:

I have a Sears table saw, Model # 137248480. I need the decal that goes on the housing for the angle tilt of the saw, but the decal is no longer available.

A:

Thank you for your question.

I have checked our sources for the label on your saw. I am sorry I could not locate it. The label is no longer available.

Something you might try is to use a hair dryer to heat he adhesive on the old decal and carefully peel it off the base. Then apply it to the new base with contact cement.

I hope this id helpful.

Read More
Mark T -
Sears Technician
September 15, 2010
A:

Just make sure to use a good quality contact adhesive. Please let me know how it works, so I can advise other customer in the future.

Read More
Mark T -
Sears Technician
September 19, 2010
See more answers